Energizer ENX1000 Instruction Manual page 7

Remove the RED/POSTIVE end first
and then the BLACK/NEGATIVE
clamp.
Do not allow the metal ends of the
jumper cables to touch each other or
the RED cables to touch anything
metal on the car.
Now unplug the BLUE end of the
jumper cable from the power bank.This
will reset the jumper cable. In 10
seconds the power bank will power off
automatically.
8. Keep the engine running 20 to 30
minutes, or drive the car to recharge
the battery.
NOTE: If the engine dies shortly after it has
been jump started, or as soon as the
jumper cables are disconnected, it probably
means the vehicle charging system is not
working (bad alternator, voltage regulator,
wiring problem or loose/dirty battery
cables). Please mechanic or vehicle's
manufacture for assistance.
POLARITY PROTECTION CIRCUIT STATUS
Status (Light & Sound
Indicator)
Red Green
Light Light
On Flashing Off
Soun
d
None The car battery is ready for jump start.
None The Power Bank needs to be charged.
TO USE A FLASHLIGHT
Press the power button for 3 seconds to
start the LED illumination.
You can then select from 2 modes
(On/SOS) by pressing the power
button lightly in sequence.
Mod
e
7