Levelling The Washing Machine - Midea MA200W75 Owner's Manual

INSTALLATION
Installation of drain hose
1.Completely sleeve the drain hose over the sewer.
2.Fix and tighten it with a hoop.( As shown in the figure )
Note!
• Note: The drain hose of the machine with upper drain system has already been
assembled before leaving the factory. This picture is suitable for lower drain system.
Under3m
Warning! Warning!
• Do not kink or protract the drain hose.
• Position drain hose properly ,otherwise damage might result of water leakage.
• If drain hose is too long, do not force it into washing machine as it will cause
abnormal noises.

Levelling the washing machine

Warning!
• The lock nuts on all two feet must be screwed tightly against the housing.
1.Check if the legs are closely attached
the cabinet. If not, please turn them to
their original positions tighten the nuts.
2.Check alignment of the product with a
spirit level and if required, correct.
3.Loosen the lock nut and turn the feet
until it closely contacts with
4.After being locked properly, press four
corners again to make sure that they has
been adjusted properly.
to
Lock nut
loosen
the floor.
Raise
9 11
Under 15cm
foot
lock
Lower
water
trough
right
wrong