Operation - Eastwood 31902 Instructions Manual

SET-UP
• Using a good quality Teflon sealing tape (Not Included), thread the 1/4" MNPT Male
quick disconnect inlet fitting into the air inlet.
CONNECTION
• Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will
quickly damage the motor and valves.
• A minimum 3/8" I.D. air line should be used for optimal performance.

OPERATION

To avoid injury, always disconnect air supply to Gun when attaching or
removing sockets or accessories.
To avoid injury, only use sockets and accessories rated for "Impact" use.
• With air supply disconnected, snap selected socket or accessory over the retaining ring nested
in the square drive.
• Connect air supply, hold tool securely and depress Trigger to begin rotating action.
- To loosen fasteners, move lever to rotate the control on the back of the drive head
Counter-Clockwise to align the cast-in arrow to the "Loosen" direction.
- To tighten fasteners, rotate control Clockwise and align arrow to select the Low,
Medium or High Torque settings (FIG 1).
FIG. 1
Reverse
(loosen)
4
INJURY HAZARD!
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
Low
Med.
Rotate
High
Forward
(tighten)