Advertisement
ASSEMBLY
• Wrap a good quality Teflon Sealing Tape (not included) around the threads of the Male 1/4" NPT
Regulator Inlet and thread into a suitable fitting or air hose.
• Wrap a good quality Teflon Sealing Tape (not included) around the threads of the Male 1/4" NPT
paint gun or other accessory inlet then thread the Regulator on to it.
INSTALLATION
• The Regulator is designed for installation at the inlet of, or as close as possible to any air tools
or spray guns to be used.
• Connect the Regulator with the cast-in directional arrow on the underside consistent with the
direction of airflow. NOTE: For best results, one of the Eastwood Air Filter/Regulators and/or
2 Stage Air Filter/Desiccant Dryer Systems should be installed before this 80 PSI Regulator.
OPERATION
• Pull upward on Locking Cap until a "snap" is heard.
• Rotate Locking Cap in a Clockwise direction as viewed from the top to increase air pressure setting.
• Rotate Locking Cap in a Counter-Clockwise direction as viewed from the top to decrease air
pressure setting.
• Push downward on Locking Cap until a "snap" is heard to lock the setting.
To order parts and supplies: 800.343.9353 >> eastwood.com
3
Advertisement
