Troubleshooting - AllPondSolutions EF1 Manual

TROUBLESHOOTING

No Motor Operation
Check power supply is connected and turned on.
1
Check impeller is correctly installed, undamaged and free from
2
blockage.
Check cable for damage - if damage is evident unplug unit and do
3
not use the EF. Do not attempt to fix, consult an electrician or other
qualified person.
Replace fuse if necessary.
4
Priming Problems
If air remains trapped in the system after initial setup, please
restart the process and follow these guidelines:
Check all hosing and pipework is connected correctly, air tight
1
and unrestricted.
Reinsert the Inlet / Outlet tap (part 1) to be sure it is securely
2
installed and set to open (lever down).
Ensure all Inlet / Outlet pipework connection points are fully
3
submerged whilst priming.
Fill the EF filter body (part 5) with aquarium water, this will aid
4
the priming of the EF.
Prime the EF without the surface skimmer (part 15) attached
5
– this can be re-attached after priming.
Ensure the EF filter body (part 5) is not over stocked with media
6
and foam as this can restrict water flow and affect the priming
function.
Excessive Noise
Ensure the EF impeller is correctly installed, undamaged and free
1
from blockage.
Follow the 'Priming Problems' troubleshooting above.
2
Restricted Water Flow
Ensure the EF impeller is correctly installed, undamaged and free
1
from blockage.
Check all hosing (part 7) and pipework is connected correctly,
2