Veer Cruiser Manual page 3

EN
02.
Cleaning &
Maintenance
• DO NOT USE VEER CRUISER WITHOUT REAR
WHEEL SAFETY FENDERS IN PLACE AND
ALWAYS KEEP HANDS AWAY FROM MOVING
WHEELS.
• ALWAYS KEEP FINGERS AWAY FROM MOVING
PARTS WHEN FOLDING, UNFOLDING, OR
ADJUSTING THE CRUISER TO PREVENT
ENTRAPMENT OR PINCHING.
• LOCK BRAKE BEFORE TRANSPORTING IN A
CAR.
• MAXIMUM CARRYING CAPACITY OF EACH SIDE
POCKET IS 0.9 KG (2 LBS).
• MAXIMUM CUP HOLDER WEIGHT IS 0.9 KG
(2 LBS). EXCESSIVE WEIGHT MAY CAUSE A
HAZARDOUS, UNSTABLE CONDITION TO ARISE.
DO NOT PLACE HOT LIQUIDS IN HOLDER.
• TOTAL WEIGHT LOAD RECOMMENDED FOR
THIS CRUISER IS 50 KG (110 LBS).
• VEER CRUISER SHOULD NEVER BE USED WHILE
ASCENDING OR DESCENDING STAIRS, OR
USING AN ESCALATOR.
• DO NOT SIT OR STAND ON THE SIDE WALL
PANELS OF THE CRUISER.
• DO NOT SIT OR STAND ON THE FOLDED SEAT
BACKS OF THE CRUISER.
• ASCEND KERBS IN PULL MODE. DO NOT
ATTEMPT TO PUSH ONTO KERBS.
• ACCESSORIES WHICH ARE NOT APPROVED BY
VEER GEAR SHALL NOT BE USED.
• NEVER USE THIS PRODUCT IF THERE ARE ANY
MISSING OR BROKEN PARTS. CONTACT VEER
GEAR FOR REPLACEMENT PARTS AND NEVER
USE SUBSTITUTE PARTS.
• THE VEER CRUISER DOES NOT REPLACE A
COT OR A BED. SHOULD YOUR CHILD NEED
TO SLEEP, THEN IT SHOULD BE PLACED IN A
SUITABLE PRAM BODY, COT OR BED.
• FAILURE TO FOLLOW THESE WARNINGS AND
INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY OR DEATH.
Store your Cruiser in a location that is out of direct
sunlight and environmental elements. If your Cruiser
is used outdoors, we recommend frequent cleaning.
Cruiser Chassis
If your Cruiser chassis parts have been exposed to
salt water, we recommend that they be thoroughly
rinsed with fresh (tap) water as soon as possible to
avoid corrosion.
If your Cruiser has been exposed to sand, use a soft
brush to gently brush sand from Cruiser parts and
cycle the components and brake until the sand is
ejected and the components cycle freely.
If your Cruiser is in need of an all over wash, remove
accessories and wheels and rinse with hose. Allow
wheels and accessories to completely air dry before
reattaching.
3