Table of Contents
Advertisement
LSSM
TESTING NOTES
Blue connectors (UPC) have a straight ferrule with a domed interface. Green connectors (APC) have an
eight-degree angled ferrule with a domed interface.
UPC and APC connectors are not compatible.
NEVER
connect UPC and APC connectors together, OR plug
an APC connector into the LSSM unit. This can cause irreparable damage to both connectors.
MAINTENANCE
UNPACKING & INSPECTION
The LSSM is supplied with a soft carry case, SC adapter installed on the unit, 3.0V CR2 battery, and an
instruction card. Contact SWIFT immediately if any part of the unit or packaging is damaged, or otherwise
unsatisfactory.
LOW BATTERY
The LSSM provides over 1000 operations under normal conditions. When the LOW BAT LED indicator is
illuminated on the device, the CR2 battery should be replaced or recharged, depending on the battery type.
OPTICAL CONNECTOR INTERFACE
The LSSM is equipped with a SC/UPC connector adapter that is compatible with only SC/UPC optical
connectors. The connector adapter interface should be kept covered and protected from contamination.
Care must be taken to avoid objects that may damage the fiber inside the adapter mount. Always inspect
and clean fibers before mating them to the device. If scratches or breaks occur on the fiber surface, please
contact SWIFT for proper service.
CALIBRATION
All SWIFT brand products include a 2-year warranty. SWIFT recommends recalibration every two years to
ensure adherence to NIST measurement standards. The first recalibration is free within the warranty period.
|
|
|
3330 Earhart Drive, Suite 208
Carrollton, TX 75006
Office: 972.556.0916
Fax: 972.910.8384
PAGE 4
Advertisement
Table of Contents
