Table of Contents
Advertisement
T1 Hall Probe System
2. Edit the TCP/IPv4 Properties
3. Select "Use the following IP
address" and enter the IP address.
Set the Subnet mask as shown.
Click "OK" and then "Close" to
close the dialogs and make the
new address effective.
If you look at the amber and green LEDs on the T-1 Ethernet port and the cable is connected,
you will see the amber light on and the green flickering when the T-1 is communicating. Now
open a web browser such as Chrome, Edge, Firefox, Safari and type the static address of the T-1
into the URL field. The T-1 will deliver its web page showing the measured field, a graph of the
field against time and various controls.
T1 User Guide
T1_UG_210314
Page 9 of 42
Advertisement
Table of Contents
