Optima Scale OP-412T Installation Manual

PRINTER INSTALLATION
OP-412T
OP-900 / OP-901 Indicator Parameter Settings
To enter calibration/parameter settings, follow the procedure below:
1. Make sure the unit is set to either kg or lb
2. Press and hold the HOLD and PRINT key at the same time for 2 seconds
3. Navigate through the settings (C01 to C18) as shown in the table below by using the arrow keys and return keys as labeled under
each indicator button
4. Press the PRINT
5. Press the ACCUM key to save and exit settings at any time
Function
Communication
Setting
Baud Rate
sales@optimascales.com
key to enter/edit the parameter setting
Parameter
C18
C19
O P T I M A S C A L E M A N U FA C T U R I N G I N C .
8 0 0 .3 6 0 . 9 6 1 9 | S AL E S@ OP T I M A S C A LE. C O M
HOW TO GUIDE
OP-412T-L1
Settings/Options
Set the serial interface data output method:
0 = Turn off serial interface data output
1 = Continuous sending mode, for remote display
2 = Print to paper thermal ticket printer (OP-412T)
3 = Command request mode, for computer.
4 = PC continuous sending mode, for computer
5 = PC/remote display, continuous sending mode
6 = Print to small label thermal printer (OP-412T-L1)
7 = Print to Zebra/large label thermal printer (OP-412T-L2)
8 = Reserved
0 = 1200 (for OP-910 remote display)
1 = 2400
2 = 4800
3 = 9600 (for all Printers and OP-910X, OP-910XL)
4 = 14400
1005 Union Center Dr. Ste b
Alpharetta, GA 30004
www.optimascales.com
9 0 3 0 BRI DG E P OR T P L AC E
R A NC HO C U C A M ONG A , C A 9 1 7 3 0
OP-412T-L2