JBL EON15 Introduction And General Information page 18

Measure the response at pin 1 of U3. Note in figure 3 above that the input voltage has not
been changed. (Voltage at pin 1 of J3). The other curve represents the response at the
output of the third section of the filter.
The third section is a low Q (Q equals about .7) high-pass filter at 33Hz.
Verify the peak frequency, 55Hz and the peak voltage 5.1V P/P. Also verify voltages at
20Hz, 30Hz, and 40Hz.
If the response is incorrect check values of C29, C30, C34, R56 and R57.
After obtaining proper response proceed to following section.
28