ABOUT THIS DOCUMENT This manual has been compiled by Jefferson Tools and is an integrated part of the product with which it's enclosed and should be kept with it for future reference. Please read all of the information supplied in this User Manual before operating this product.
PLEASE NOTE THE FOLLOWING PHOTOGRAPHS & INSTRUCTIONS ARE FOR REFERENCE ONLY AND MAY DIFFER FOR YOUR COMPRESSOR MODEL. PLEASE CONTACT JEFFERSON TOOLS IF YOU NEED ANY ADVICE ON THE ASSEMBLY PROCEDURE. Fig.1 Fig.2...
Check the oil Level: Before using the compressor check the oil level using the dipstick. If the oil is not up to the mark it should be topped up with Jefferson HT68 Compressor Oil (see Fig.6). Sight glass / Oil Level: The compressor oil level can be viewed through the sight glass;...
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE SAFETY GUIDELINES Read and ensure that you understand all of the operating instructions, safety precautions and warnings in this Instruction Manual before operating or maintaining this compressor. Most accidents that result from compressor operation and maintenance are caused by the failure to observe basic safety rules or precautions.
Page 9
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry thoroughly. • Only use Jefferson approved replacement parts. Non-approved parts will void your warranty and can lead to malfunction and resulting injuries. Genuine parts are available from Jefferson your dealer.
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE WARNING LABELS Label Potential Hazard Prevention Water directed at electrical connections or switches, or Never attempt to clean the air compressor while it is objects connected to an electrical circuit, could result in running.
If the valve is replaced the compressed air contained in the system must be discharged first. WARNING: Jefferson Tools cannot take any responsibility for damage caused to persons and/or things due to failure to observe these instructions. OPERATION GUIDE ON/OFF SWITCH Prior to connecting the compressor to the power supply, ensure the pressure switch is on the OFF position.
Page 12
Press button. If after restarting the overload cut out is activated again, switch off the machine, Fig.12 disconnect the power supply and contact your Jefferson Dealer for advice. NOTE: For technical specifications and detailed instructions please refer to the instructions provided with the specific air tool/accessory. The outlet line pressure from the tank is adjusted using regulator.
Replace the oil cap and be sure to tighten this nut securely (you can use some PTFE tape on the thread to help create a tighter seal before tightening). • Fill the oil reservoir with a compatible compressor oil (e.g Jefferson HT68 Compressor Oil). Checking / Cleaning the Air Filter •...
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE TROUBLESHOOTING FAULT CAUSE REMEDY Tank pressure drops continually. Air leak, check all connections. Locate and rectify leak. Run the compressor at maximum pressure then switch off and disconnect. Brush a soapy water solution over the connections and look for bubbles.
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE ENVIRONMENTAL PROTECTION Recycle any packaging and unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE PARTS LIST - MAIN ASSEMBLY Quantity Description Quantity Description Air Tank Belt Guard Hex. Nut 30.1 Belt Guard Caster Wheel 30.2 Belt Guard Axle V-Belt Wheel Hex.
Bratislava Country : Slovakia #1354 Equipment Category: Air Compressor (Item 8) Product Name/Model: 200L Air Compressor JEFC200L10B-230 - 200L Air Compressor • 230V • 3HP • 10Bar • Belt Drive Measured Sound Power Level: 96dB Guaranteed Sound Power Level: 96dB...
Jefferson will assume both the parts and labour expense of correcting defects during the stated warranty periods below. All warranty periods start from the date of purchase from an authorised Jefferson dealer. If proof of purchase is unavailable from the end user, then the date of purchase will be deemed to be 3 months after the initial sale to the distributor.
Page 22
• A Warranty Returns form will be sent to you for completion and return by post or fax, together with details of your nearest authorised Jefferson repair centre. On receipt of this form Jefferson will arrange to collect the equipment from you at the earliest convenience.
Page 23
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE www.jeffersontools.com...
USER MANUAL JEFC200L10B-230 200L AIR COMPRESSOR • 230V~50Hz • 3HP • 10Bar • BELT DRIVE IMPORTANT! SAFETY FIRST! Before attempting to use this product please read all the safety precautions and operating instructions outlined in this manual to reduce the risk of fire, electric shock or personal injury.
Need help?
Do you have a question about the JEFC200L10B-230 and is the answer not in the manual?
Questions and answers