Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Jefferson TANDEM JEFC270T10B-230
Summary of Contents for Jefferson TANDEM JEFC270T10B-230
- Page 1 TANDEM 2x 3HP • BELT-DRIVEN JEFC270T10B-230 User Manual v.2.1...
- Page 2 USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar www.jeffersontools.com...
-
Page 3: Table Of Contents
EC Declaration of Conformity Limited Warranty Statement Important: This manual has been compiled by Jefferson Tools and is an integrated part of the product with which it's enclosed and should be kept with it for the future reference. This manual describes the purpose for which the product has been designed and contains all the necessary information to ensure its correct and safe use. -
Page 4: Introduction
10bar (145psi) Cylinders: Pump Speed: 1086rpm Air Displacement: 29.6cfm / 836L/min Free Air Delivery: 17.6cfm / 298L/min Guaranteed Sound Power: 97 dB LWA Lubrication Oil: Jefferson HT68 Compressor Oil Weight: NW: 190kg / 418Ibs Dimensions: 1555 x 510 x 1020mm www.jeffersontools.com... -
Page 5: Unpacking & Assembly
PLEASE NOTE THE FOLLOWING PHOTOGRAPHS & INSTRUCTIONS ARE FOR REFERENCE ONLY AND MAY DIFFER FOR YOUR COMPRESSOR MODEL. PLEASE CONTACT JEFFERSON TOOLS IF YOU NEED ANY ADVICE ON THE ASSEMBLY PROCEDURE. Fig.1 Fig.2... -
Page 6: Equipment Identification
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar EQUIPMENT IDENTIFICATION 1. Air Tank 2. Ball Valve / Air Outlet 3. Pressure Gauge 4. Pressure Switch 5. Pump Assembly 6. Air Filter 7. Motor Assembly 8. -
Page 7: Before First Use
Check oil Level: Before using the compressor check the oil level using the dipstick. If the oil is not up to the mark it should be topped up with Jefferson HT68 Compressor Oil (see Fig.6). Sight glass / Oil Level: The compressor oil level can be viewed through the sight glass;... -
Page 8: Safety Guidelines
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar SAFETY GUIDELINES Read and ensure that you understand all of the operating instructions, safety precautions and warnings in this Instruction Manual before operating or maintaining this compressor. Most accidents that result from compressor operation and maintenance are caused by the failure to observe basic safety rules or precautions. - Page 9 Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry thoroughly. • Only use Jefferson approved replacement parts. Non-approved parts will void your warranty and can lead to malfunction and resulting injuries. Genuine parts are available from Jefferson your dealer.
-
Page 10: Warning Labels
If the valve is replaced the compressed air contained in the system must be discharged first. • WARNING: Jefferson Tools cannot take any responsibility for damage caused to persons and/or things due to failure to observe these instructions. OPERATION GUIDE TO START THE COMPRESSOR: •... - Page 11 In the event of an overload cut-out, please allow 5 minutes for the machine to cool prior to attempting to reset the overload cut-out. If, after resetting the overload cut-out, the overload is activated again, switch off the machine, disconnect the power supply and contact your Jefferson Dealer for advice. Fig.12 EFFICIENT OPERATION...
-
Page 12: Electrical Connections: Control Box & Wiring Diagram
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar ELECTRICAL CONNECTIONS: CONTROL BOX & WIRING DIAGRAM www.jeffersontools.com... -
Page 13: Maintenance
Replace the oil cap and be sure to tighten this nut securely (you can use some PTFE tape on the thread to help create a tighter seal before tightening). • Fill the oil reservoir with a compatible compressor oil (e.g Jefferson HT68 Compressor Oil). Checking / Cleaning the Air Filter •... -
Page 14: Troubleshooting
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar TROUBLESHOOTING FAULT CAUSE REMEDY Tank pressure drops continually. Air leak, check all connections. Locate and rectify leak. Run the compressor at maximum pressure then switch off and disconnect. Brush a soapy water solution over the connections and look for bubbles. -
Page 15: Environmental Protection
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar ENVIRONMENTAL PROTECTION Recycle any packaging and unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable, reaches the end of its working life and requires disposal, drain off any fluids (if applicable) into approved containers and dispose of the product and the fluids according to local regulations. -
Page 16: Parts Diagram - Main Assembly
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar PARTS DIAGRAM - MAIN ASSEMBLY www.jeffersontools.com... -
Page 17: Parts List - Main Assembly
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar PARTS LIST - MAIN ASSEMBLY Quantity Description Quantity Description Ball Valve SP Washer Plug Hex.Bolt Air Tank Guard bracket Hex.Nut Nut.Hex Rubber pad Hex.Bolt Plate Washer Pump Hex.Bolt Hex.Bolt... -
Page 18: Parts Diagram - Pump
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar PARTS DIAGRAM - PUMP www.jeffersontools.com... -
Page 19: Parts List - Pump
USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar PARTS LIST - PUMP Quantity Description Quantity Description Hex Bolt Bearing Cover SP Washer Gasket Pl Washer Oil Sight Glass Fly Wheel Seal Ring Lower Cover Hex Bolt Hex Bolt Oil Seal... -
Page 20: Ec Declaration Of Conformity
270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar EC Declaration of Conformity We, Jefferson Professional Tools & Equipment, as the authorised European Community representative of the manufacturer, declare that the following equipment conforms to the requirements of the following Directives:... -
Page 21: Limited Warranty Statement
Jefferson will assume both the parts and labour expense of correcting defects during the stated warranty periods below. All warranty periods start from the date of purchase from an authorised Jefferson dealer. If proof of purchase is unavailable from the end user, then the date of purchase will be deemed to be 3 months after the initial sale to the distributor. - Page 22 • A Warranty Returns form will be sent to you for completion and return by post or fax, together with details of your nearest authorised Jefferson repair centre. On receipt of this form Jefferson will arrange to collect the equipment from you at the earliest convenience.
- Page 23 USER MANUAL JEFC270T10B-230 270L BELT DRIVEN AIR COMPRESSOR • TANDEM 2x 3HP • 10Bar www.jeffersontools.com...
-
Page 24: Www.jeffersontools.com
Before attempting to use this product please read all the safety precautions and operating instructions outlined in this manual to reduce the risk of fire, electric shock or personal injury. Jefferson Tools, Herons Way, Chester Business Park, Chester, United Kingdom, CH4 9QR Tel.
Need help?
Do you have a question about the TANDEM JEFC270T10B-230 and is the answer not in the manual?
Questions and answers