Adjusting Buttonholes - Brother XL-2600 Operation Manual

3 Cut an opening in the middle of the
buttonhole with the seam ripper tool. Be
careful not to cut through any stitches.
CAUTION
●
When using the seam ripper to open the
buttonhole, do not put your hand or
finger in the path of the ripper. The seam
ripper may slip and you may be injured.

Adjusting Buttonholes

If the stitching on the two sides of the buttonhole is
not the same, you can make the following
adjustments.
1 Set the stitch length dial between "F" and 1.5
and sew the buttonhole on a scrap piece of
fabric to observe how the material is fed.
2 If the right side of the buttonhole is too coarse
or fine, adjust the feeding of the material with
the stitch length dial.
2
1 Right side
2 Shorter
3 Longer
1
3
3 After obtaining a satisfactory feed on the right
side, stitch the buttonhole and observe the
feeding.
4 If the left side is too coarse or fine compared
with the right side, adjust the buttonhole fine-
adjustment screw as described below.
If the left side is too coarse, turn the buttonhole
fine-adjustment screw with a large screwdriver
–
in the direction.
If the left side is too fine, turn the buttonhole
fine-adjustment screw with a large screwdriver
+
in the direction.
• This adjustment ensures both sides of the
buttonhole are the same.
4
1 Stitch length dial
2 Buttonhole fine-adjustment screw
3 Left side
4 Buttonhole appearance
2
1
3
4
35
4