Adjusting The Swift-Tach Stand - Kubota LA535 Operator's Manual

HOW TO REINSTALL THE LOADER
16. Make sure that the stand lever is at its low position
as shown in the following figure.
(1) Stand lever
17. Slowly dump the bucket until the stands are in the
stowed position.
18. Using the stand lever lock the stands in the stowed
position as shown below.
(1) Stand lever
IMPORTANT :
• Do not force the stand lever if it gets twisted
halfway and fails to stow away the stand. In
such case, lower the stand lever and move
the bucket to the full roll back position. Then
go back to step 13. and take its following
steps.
19. Verify LH/RH stand hooks are engaged properly as
shown below.
LA535
REINSTALLING THE LOADER
(1) Stand

3. Adjusting the swift-tach stand

If the stand does not hook and fold up successfully,
readjust the height of lifting stand, referring to the
following steps.
1. Ensure that the left and right stand adjusting plate is
in the lowest possible position as seen in the figure.
(1) Stand Adjusting Plate
2. Raise the boom until the bucket pivot pin is the
same height as the boom pivot pin as seen in the
figure.
(1) Bucket pivot pin
(2) Boom pivot pin
(2) Stand hook
(A) Lowest possible position
(A) Same height
47