Assembly - Makita UB400MP Original Instruction Manual

ASSEMBLY

WARNING:
Before assembling or adjusting
the equipment, switch off the motor or engine and
remove the spark plug cap or battery cartridge.
Otherwise, the fans may move and result in an injury.
WARNING:
When assembling or adjust-
ing the equipment, always put it down.
Assembling or adjusting the equipment in an
upright position may result in serious injury.
WARNING:
Follow the warnings and pre-
cautions in the chapter "SAFETY WARNINGS"
and the instruction manual of the power unit.
Mounting the attachment pipe
CAUTION:
Always check that the attach-
ment pipe is secured after installation. Improper
installation may cause the attachment falling off
from the power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1. Remove the cap from the end of the pipe.
► 1. Pipe 2. Cap
NOTICE:
Do not dispose of the cap
since the cap is necessary for storing the
attachment.
2.
Turn the lever toward the attachment.
► 1. Lever
1
2
1
8
3.
Align the pin with the arrow mark on the
power unit. Insert the pipe until the release but-
ton pops up.
Make sure that the position line is on the tip of
the arrow mark on the power unit, and the arrow
mark on the power unit and the arrow mark on
the pipe are facing each other.
► 1. Release button 2. Arrow mark on the
power unit 3. Pin 4. Position line 5. Arrow
mark on the pipe
4. Turn the lever toward the power unit.
1
► 1. Lever
Make sure that the surface of the lever is parallel
to the pipe.
NOTICE:
Do not tighten the lever without
the attachment pipe inserted. Otherwise
the lever may tighten the entrance of the drive
shaft too much and damage it.
ENGLISH
1
2
3
4
5