INSTALLATION
Installation area
Warning!
•
Stability is important to prevent the product from
•
Make sure that the product should not stand on the power cord.
Before installing the machine, the location characterized
follows shall be selected:
1.Rigid, dry, level surface
2.Sufficient ventilation
3.Keep far away from the heat resources such as coal or gas.
Change the position of the drain hose
The ex-factory installation position of the drain hose is located
According to the installation site, the drain hose can also be
side of the machine . The method is as follows:
1 Unplug the power cord and empty water in the drain hose
.
completely.
2 Spread a piece of soft cloth on the floor (e.g. a blanket)
.
and place the washing machine on it gently.
3.
Take the drain hose out from the buckle at the spin side,
and
put it into the buckle at the wash side.
4.
Hang up the drain hose kit.
There are two ways to place the end of drain hose:
1.For lower drain system
Under3m
2.For upper drain system
Warning!
•
Do not kink or protract the drain hose.
• Position drain hose properly ,otherwise damage might result of water leakage.
• If drain hose is too long, do not force it into machine as it will cause abnormal noises.
and Avoid direct sunlight
, Room temperature is above 0 C
Trough
Hose
Retainer
6
wandering!
w
W> 20mm
as
at
installed
Blanket
Drain hose
Under 15cm
w
the spin side .
at the wash
Front
water trough