Brother P-Touch PT-1900 User Manual page 32

3 Press r. The text is automatically formatted for the installed stamp: centered within
the preset message area with the tape length and margins automatically adjusted.
4 Press p to cut the text out of the stamp stencil film.
5 After the stamp stencil film is cut off, remove the backing paper from the stamp stencil
film and affix it to the ink pad of a stamp film holder.
EXAMPLE
To cut a stamp:
1
Enter the text and insert a stamp film cassette in the tape compartment.
2
Hold down
r
3
Press
p
4
Press
then automatically cut it off.
To affix a stamp:
5
Remove the stamp frame from around the stamp
film holder ink pad, one side at a time, and then
remove the protective seal covering the ink pad
and the backing paper from the stamp stencil film.
6
With the glossy side of the stamp stencil film
upward, align one of its ends with the slit on the
side of the stamp film holder.
24
c U
and press
.
to engrave the stamp stencil film, and
.
Tape end
Glossy side
Slit