Modifying Temperature Until The Next Switch In The Program - Computherm E400RF Instruction Manual

times (temperature, hour value of the time, minute value of the time).
- Values are always set by
After the program of weekdays has been set, you can set the program
of the days of the weekend. The day and switch being set are shown
by the icon flashing on the display.
d) Programs that were set earlier can be checked at any time by repeating
the steps of programming mode.
Attention! In the interest of logical programming ensure that in programming
the times of successive switches succeed each other during the course of the
day, i.e. you should specify switches in chronological order.

12.2.3. Modifying temperature until the next switch in the program

If the thermostat is in programmed mode, but you want to temporarily change
the set temperature until the next program switch, you can do so as follows:
• Using the phone application: using the
ve) on the circular scale, the
the icon.
• On the thermostat: using the
and at the same time.
The set temperature this way will remain in effect until the next program switch.
buttons.
icons or mo ving the slide (groo-
icon will appear in the application instead of
buttons. The thermostat's display will show
- 34 -