Advertisement
8. Battery Capacity Detection:
Use "Battery Get" command to have the battery capacity back in %. It will detect the
battery capacity automatically. Low Battery Auto Report (low battery is set as 2.4+/-0.1
Voltage).
9. Association:
* Support one group with 1 node.
* Group 1 = Lifeline (Battery, Notification, Reset Locally)
10. Support Explorer Frame Function
11. All the rest commands depend on Z-Wave standard
12. Factory Default Reset:
Quick press the button of ZA1502-7 4 times and hold the button around 5 seconds
until the Red LED is on to send the "Device Reset Locally Notification" command and
reset to the factory default.
(Remark: This is to be used only in the case of primary controller being inoperable or
otherwise unavailable.)
13. Support OTA Firmware update from controller. Please refer to your controller manual.
Once OTA function success, we recommend you exclusive the device & inclusive
again before use the device.
14. Support SECURITY S0, SECURITY S2 UNAUTHENTICATED & SECURITY S2
AUTHENTICATED.
15. Support SmartStart, please scan the QR Code from ZA1502-7 for SmartStart. QR
code and PIN is located on the device, also there is a Full DSK string on the enclosed
DSK card. Please keep DSK card carefully for future inclusion needed.
(P.S.: Z-Wave SmartStart aims to shift the tasks related to inclusion of an end device
into a Z-Wave network away from the end device itself, and towards the more
user-friendly interface of the gateway.)
16.
The DSK label will on the backside of ZA1502-7, Scan the DSK label to access
the SmartStart if gateway 's UI supports SmartStart. (Remark: The QR code is for
use with Z-Wave SmartStart by using "DSK," "Device Specific Key," "PIN," or "PIN
code," etc.)
17. Enable/ Disable SmartStart:
Press the button of ZA1502-7 3 times continuously and hold the button around 5
seconds until the Red LED and Green LED is flashing sequentially. Enable and
Disable is under a circle switching. The default status is "Enable" after every time's
power on.
P.S.: The LED indicator for Enable / Disable SmartStart:
- Enable: One time's LED flashing. (Red → Green)
- Disable: Two times' LED flashing. (Red → Green → Red → Green).
18. A Security Enabled Z-Wave Controller must be used to fully utilize the products.
- 5 -
Advertisement
