CLEANING THE CONTROL PANEL AND
Use a standard neutral soap detergent to clean the
control panel and housing.
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
CAUTION! Do not use furniture
cleaning agents or cleaning agents
which can cause corrosion.
WARNING! Refer to Safety chapters.
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised
WARNING! Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an error code and
Start/Pause button may flash continuously:
If the display shows other error codes, deactivate and activate the appliance. If the problem continues,
contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
Appliance motor overloaded.
Too much laundry or entrap in the
Internal fail. No communication be-
tween electronic elements of the ap-
The mains supply is unstable.
CLEANING THE AIRFLOW SLOTS
Use a vacuum cleaner to remove fluff from the
The programme was not completed.
Remove the laundry from the drum,
set the programme and restart the cy-
The programme was not finished
properly or the appliance stoped too
early. Switch the appliance off and on
If the error code appears again, con-
tact the Authorised Service Centre.
When the appliance is showing EH0,
please wait until main supply is stable
than press start. If the appliance
pause the cycle without any indication
then press the cycle start. If the warn-
ing will occur check the power cord /
socket integrity or main supply.