Warmup WMD1 Installation Manuallines

Simple Installation:
• Lay the mirror face down on a protective surface.
• Make sure the back of the mirror is clean and free from
grease and residues.
• Mark the back of the mirror where the heater is to be
positioned. The heater should be at least 10 mm from
the edges of the mirror.
• Peel back the protective release paper from one
corner of the mirror heater. Position this corner in the
required corner of the marked area and slowly peel
back the release paper whilst applying gentle pressure
to remove air bubbles.
• The Warmup® Mirror Demister must be connected to
a loghting circuit or to an electrical circuit through
a separate 5 amp switch. The installation must be in
accordance with regulations.
(Detailed instructions inside)
Register your product online at www.warmup.co.uk
Warmup Plc 702 Tudor Estate, Abbey Road, London, NW10 7UW
T. 0845 345 2288 F. 0845 345 2299 E. uk@warmup.com
warmup.co.uk
Complete and submit the warranty
form online
at www.warmup.co.uk
IMPORTANT
Read this manual before
attempting to install
your heater. Incorrect
installation could damage
the heater and will
invalidate your warranty.
IP57
V0211
Installation Guidelines:
Mirror
Demister
The Warmup® Mirror Demister is designed to warm bathroom
mirrors, leaving them clear and free of condensation.
Four sizes of heaters are available - two rectangular versions
(450mm X 400mm and 600mm X 1100mm), a circular (600mm
diameter) and a squarish (290mm X 290mm); all 220-240 Volts.
The heaters are self adhesive, have an IP rating of 57 and are
SEMKO certified.
The mirror used in the application must be suitable for purpose
and the instructions provided by the mirror supplier must be
adhered to.
If at anytime the heater is damaged, please contact the Warmup
Technical Helpline on 0845 345 2288.
Model Size Voltage Amperage Resistance
WMD1 400mm X 450mm 230 0.08
WMD2 600mm circular 230 0.24
WMD3 290mm X 290mm 230 0.12
WMD4 600mm X 1100mm 230 0.57
NOTE: When testing the resistance of the mirror demister allow a ±10% tolerance
for pads above 25w and +20% for pads below 25w.
Wattage
2939 18
960 55
1959 27
401 132