Electrical Specifications; Power Requirements; Optional Power Input; Regular Mode - Output Specifications - Sota MP6 Manual

The Magnetic Pulser Model MP6 Manual
When used as part of a Wellness Protocol, daily use for many weeks is more
important for results than using occasionally. For specific purposes, longer and more
frequent sessions may be more beneficial. Generally, the Magnetic Pulser can be used
as needed.
Placement: The Hand Paddle may be kept on one location for one or more cycles. It
may also be moved at any time to a different location.
Drink plenty of water: It is important to drink enough water when using the unit.
Drinking ozonated water is especially helpful.
Stop Gradually: Reduce the amount of time each day for the last week of use. If
using more than one SOTA unit at a time, it is suggested to stop only one unit at a
time.

ELECTRICAL SPECIFICATIONS

Your Magnetic Pulser outputs a time-variant pulsed DC magnetic field.

POWER REQUIREMENTS

12 Volts DC @ minimum 1.5 Amps, Tip or Center Positive.
Caution: Exceeding the voltage rating or reverse connection may result in injury or
unit failure. This will void the warranty.

OPTIONAL POWER INPUT

To operate the Magnetic Pulser from a 12 Volt DC source, such as an automobile
battery or an appropriate Solar Panel, purchase a Universal Power Cord with Tip or
Center Positive polarity.

REGULAR MODE - OUTPUT SPECIFICATIONS

Magnetic Field Intensity: Greater than 6000 Gauss at face of the Hand Paddle as
tested with an F.W.Bell 5080 Tesla Meter.
Pulse Duration: ~2.5 mS (milliseconds).
Pulses per Cycle: 255 pulses (approx. 20 - 30 minutes).

FAST MODE - OUTPUT SPECIFICATIONS

Magnetic Field Intensity: Greater than 2500 Gauss at face of the Hand Paddle as
tested with an F.W.Bell 5080 Tesla Meter.
Pulse Duration: ~2.5 mS (milliseconds).
Pulses per Cycle: 1400 pulses (approx. 20 - 30 minutes).
© 2015-2021 SOTA Instruments Inc. Page 6 of 7| www.sota.com