Operating And Regulating The Machine; Maintenance; Warranty - Benassi AF200SL Operation And Maintenance Manual

6. OPERATING AND REGULATING THE MACHINE

• Before starting to use the leaf-sucker check the fixing of the suction opening.
• Check the fixing of the bag and that the bag is not torn.
• The machine moves forward by pulling the lever "G" Pic.9.
• If the clutch slips or the lever is too hard to be pulled, you can regulate the clutch wire through the
adjuster Ref. "H" Pic.9;
• When the vac-bag is full or very heavy, go next to the unloading area, switch off the engine, open the
zipper at the back of the bag (see Pic.10) and empty it. It is also possible to uncouple the bag from
the handlebar by lifting the two hands with hole from the pins (Ref. "I" Pic.9), and loosening the belt .
• The height of the suction opening can be regulated easily through the knob (Ref. "L" Pic.11.). The
height van vary from 2 to 11 cm. from the ground, and it depends on the material that must be
sucked.
• You can fix an accessory consisting of a flexible pipe ending with a stiff piece of pipe with knob
(Pic.12.) if sucking must be carried out in narrow places inaccessible to the leaf sucker.
• You can fix this accessory by loosening the knob that fastens the opening (ref. "P" - pic.3), taking
away the opening of the central body and fitting the flexible section pipe. Pay attention that the plate
presses the button of the microswitch and screw the knob again.
IMPORTANT ! ! !
IF THE LEAF-SUCKER IS USED IN VERY DUSTY PLACES IT MUST BE PERIODICALLY
CLEANED BY REMOVING THE DUST. THE OBSTRUCTION OF THE BAG DUE TO THE
DUST CAN CAUSE ITS BREAKING. DO NOT ASSEMBLE THE BAG IF IT IS WET. CARRY
OUT THE OPERATION ONLY WHEN THE ENGINE IS SWITCHED OFF.

7. MAINTENANCE

For changing the oil and other maintenance operations on the engine(spark plugs, air filter, regulations),
refer to the engine manual provided.
Clean periodically the bag from the dust. Do not assemble the bag if it is wet

8. WARRANTY

Our machines and accessories are guaranteed for 2 years excluding electric and rubber parts.
All the defective parts will be replaced free of charge excluding cost of labour and transport freight, which
would be at customer's charge.
For any problem regarding the engine or any other part not of our production, please refer to the
guarantee conditions stated by the manufacturer and apply to their assistance centres.
For any kind of problem or repair please apply to the dealer where you bought the machine.
AF200SL
29