Benassi AF200SL Operation And Maintenance Manual page 28

5. STARTING AND STOPPING THE LEAF-SUCKER
Before starting the motor, always make a careful check of the following :
•
Check the engine oil level :IMPORTANT : MACHINES OUT OF THE FACTORY DO NOT CONTAIN
OIL IN THE MOTOR. Add oil up to the oil level on the dipstick.(Pic.5)
•
The engine can be damaged if it runs with an insufficient quantity of oil.
•
PLEASE REFER TO THE ENGINE OPERATION AND MAINTENANCE MANUAL UNDER THE
HEADING "BEFORE START-UP"
•
Always start-up the machine outdoors.
1. Place the motor lever (ref. "D" - pic.6) in the "CHOKE" position (this is necessary only to start the
engine when it is cold)
2. Place the accelerator lever Ref. "E" Pic.7 in the intermidium position.
3. Open the petrol tank (Pic. 6 Ref."S") by turning it to the "ON" position.
4. Make sure that the switch of the stop engine is in position "ON", see ref."T" picture 6.
To stop the engine put the red lever in position (O). (pic. 6a)
Meaning of the symbols for engines with switch: O = OFF and I = ON
5. Pull slightly ("F" Pic. 8) until feeling a some resistance, then pull harder. When the engine is running,
the cord should not be released suddenly, but should be guided back until it is rewound completely.
6. Once the engine is running place the motor lever (ref. D - pic.6) in the "RUN" position.
7. To stop the engine place the switch ref. "T" - Pic.6 in the "OFF" position.
28
AF200SL