Climax Technology WTRS Series Manual

Emergency Pendant/Wrist Transmitter
(WTRS/WTRS2 Series)
Easy & Exchangeable Belt / Long battery life / Waterproof
 Active Button

Pressing the Active Button for more than 1 second will activate the Control Panel, causing it to
dial emergency call or alarm.

Press and hold the Active Button for 8 seconds to send a Cancel Code to the Control Panel.
(This function is not compatible with every control panel).

Before learning the Transmitter into the Control Panel, press and hold the button for 15 seconds
until the LED flashes 3 times to activate the Auto Low Battery Detection function.
WTRS/WTRS2 will automatically check battery voltage every 20-24 hours.
 Learn in the Transmitter
Step 1. Put the Control Panel into learning mode.
Step 2. Press the Active Button on the Transmitter. A radio signal will be transmitted to the Control
Panel.
Step 3. Please refer to the operation manual of your Control Panel to complete the learning
process.
 Battery Life
The Transmitter uses one CR2032 3V Lithium battery as its power source.
Every time the Active Button is pressed, the Wrist Transmitter will check the battery voltage. If low
battery status is detected 3 times in a row, the Wrist Transmitter will transmit Low Battery signal
along with regular signal every time the button is pressed.
<NOTE>

A 30-second interval is required between each Active Button press to check the battery voltage
again.
 Auto Low Battery Detection
The Wrist Transmitter features Auto Low Battery detection function.

Press and hold the Active Button for 15 seconds to activate this function. Please ignore the LED
flashes at the 1
enabled.
st and the 8 th seconds. The LED will flash three times when the function is
1