Check The Print Quality - Brother MFC-250C Quick Setup Manual

h
Gently push the ink cartridge until it clicks. After
all the ink cartridges are installed close the ink
cartridge cover.
Note
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
5

Check the print quality

a
When the preparation process has finished, the
LCD shows this message
..
Set Paper and
Press Start
Press Colour Start.
b
Check the quality of the four colour blocks
on the sheet. (black/yellow/cyan/magenta)
6
q
c
If all lines are clear and visible, press 1 (Yes)
on the dial pad to finish the quality check.
If you can see missing short lines, press 2 (No)
on the dial pad and go to d.
d
The LCD asks you if the print quality is OK for
black and colour. Press 1 (Yes) or 2 (No) on
the dial pad.
.
Black OK?
1.Yes 2.No
.
Color OK?
1.Yes 2.No
After pressing 1 (Yes) or 2 (No) for both black
and colour, the LCD shows:
a
.
Start Cleaning?
1.Yes 2.No
e
1 1
Press 1 (Yes), the machine will then start
cleaning the colours.
f
After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again. Go back to b.
OK
Poor
q
q
q