Advertisement
10/19
4. OPERATION
Never use this truck support stand to support both ends and/or one side of a vehicle!
Use only as a pair per vehicle.
1. Borum Truck Support Stand is designed to support a rated capacity, partial vehicle loads
consisting of one end of a vehicle. Use as a matched pair to support one end of a vehicle only.
2. Do not exceed the rated Safe Working Capacity. Overloading can cause damage to, or failure of
the support stand.
3. This Borum Truck Support Stand is designed for use on a hard level surface capable of sustaining
the load.
4. Position this Borum Truck Support Stand to only support on the areas of the vehicle as specified
by the vehicle manufacturer.
5. Always support the load on a support stand immediately after lifting the vehicle with appropriate
lifting equipment and before working on or under the vehicle.
6. Always centre load on saddle prior to lowering load on to this support stand.
7. Always lower load slowly with care.
8. Do not raise or lower the vehicle unless tools, materials and people are clear. When the load is
being lowered, make sure everyone is standing at least 2metres away. Be sure there are no tools
or equipment left under or around before lowering.
9. Always lower load slowly with care.
10. Wear approved safety personal protective equipment and steel cap footwear during use.
11. Do not move or rock vehicle load whilst this Borum Truck Support Stand is supporting the load.
12. Stay alert. Use caution and common sense when working with this Borum Truck Support Stand.
13. Do not use when tired, incoherent, dizzy, under the use or drugs or alcohol.
Training -Read this manual before use. Do not allow anyone who has not read this manual,
and/or does not understand the requirements, use the equipment.
Spectators -Do not allow bystanders around this Borum Truck Support Stand or under the load
supported only by this Borum Truck Support Stand. Do not allow anyone in the vehicle whilst this
Borum Truck Support Stand is in use. Keep all bystanders away from vehicle when in use.
Positioning Load
1. Adjust saddle height by pulling up the extension tube, then insert the locking pin through the hole
on extension tube.
2. Ensure that locking pin is secured before loading. Insert locking pin into the extension tube far
enough to create equal distance of pin extending from the extension tube on both sides.
3. Carefully position support stand, so that load is centered on the support stand saddle.
4. Slowly lower the vehicle onto the support stand.
5. Check to ensure vehicle is secured before working on, around or under. Use wheel chocks on all
un-lifted wheels in both directions to prevent inadvertent movement.
Lowering Load
1. WARNING: Clear all tools and personnel before lowering load.
2. With a suitable lifting device, raise vehicle clear of the support stand.
3. Carefully release the locking pin and allow extension tube to glide down to its lowest position.
4. Carefully remove the support stand, then carefully lower vehicle with the lifting device.
Made in china to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
10TSS
P a g e
| 4
Advertisement
