PoolRite ChloroMaster Quick Start Manual

Customer Responsibility
Your "Before You Call For Service" Checklist
Before calling for service read the instructions in this Quick Start Guide carefully.
The following points are your responsibility:
• Power point not turned on or faulty (check with another appliance)
A service charge will be made
• Time switch incorrectly set
for service as a result of the
adjacent points
• Unit incorrectly installed
Pump not plugged int ChloroMaster Pump Outlet Socket
•
• Controls incorrectly set
• Poor water chemistry (salt level, pH etc.)
• Cell not being cleaned (acid wash) properly.
• Poor water flow (check filter is clean / pump operating / skimmer free of obstructions)
• Unit being tampered with by unauthorised persons.
Warranty Terms and Conditions
Your new ChloroMaster chlorinator is manufactured to the highest possible standards using the most up-to-date
technology. Accordingly the equipment carries the following Warranty, should a fault occur due to faulty
manufacturing or materials.
Important: In the event of a fault covered by warranty occuring, the purchaser must, in the first instance, contact
Poolrite
warrant the original purchaser of the Power Pack and Electrolytic Cell for a period of 24 months from the date of
purchase by the original owner, with the Cell also warranted for an additional
examination disclose to its satisfaction that the Electrolytic Cell or Power Pack has failed due to faulty
manufacturing or materials.
The Warranty is Void if the following occurs:
• Operating the product and/or cleaning the cell other than in accordance with this Quick Start Guide
• Damage caused from mechanical cleaning (eg. use of a screw driver or other sharp implement)
• The safety flow detector, power terminals and/or connections have been tampered with
All salt water
• Cell power terminals have been submerged in acid solution whilst cleaning
chlorinators have been fully
tested and approved by the
• Incorrect water chemistry (refer to Chemical Balance Guide under Maintenance instructions)
Queensland Electrical Safety
• Salt level below 3000 ppm or above 7000 ppm.
Office and have been issued
• The chlorinator is installed on a pool size which is not recommended for its model
with an AS/NZS 3136 Certificate
• The Power Pack has been serviced by a person other than a person authorised to do so by Poolrite or its agent
of Approval.
• Non-swimming pool grade salt has been used in the pool
• Metal based algaecides have been used
• Insect / vermin infestation
Additionally the Power Pack is
rated as complying with IPX as • Fuse is blown
per AS1939 and as such can be
legally installed within the
designated Pool Zone as
defined in Section 7 of AS/NZS
3000 wiring rules.
Manufactured by Poolrite
Email: poolrite .com Web: www.poolrite
PH +617
Pty. Ltd. or the closest authorised distributor. Poolrite
• High levels of metallic ions in water
• Excessive Cleaning and/or Exessive Scaling
• Negligence and/or Acts of God
Pty Ltd ABN
.com
F X +617
installation installation
Heaters and other
equipment in the return
to pool line must be
pro-rata, should
installed before the cell
(i.e. Between the cell
and filter)
Remember:
The filter pump must be
plugged into the Power Pack.
When secure, plug the lead
into a suitable 240 volt power
point, but DO NOT SWITCH THE
UNIT ON
Connecting a pump load
greater than 1.5kW, or the use
of double adapters/stackable
plugs will void the warranty.
FOR FURTHER INFORMATION PLEASE REFER TO:
operation operation
installation installation
ChloroMaster Cell
ChloroMaster
ChloroMaster Power Pack
Connecting the Pool Pump
Off-Peak Installations
ChloroMaster
www.poolritesystems.com.au
maintenance maintenance