Advertisement
Klever Desk
Flush Mount Handset (Upgrade)
™
Operating Instructions
Designed in Europe, but built for corporate New Zealand workplaces, Klever Desk
™
hand control
complements the function with its four-digit display, and space for up to two saved memory positions.
kleverdesk.co.nz
Release Version 1.0 2021
Advertisement
Table of Contents
Related Manuals for Klever Desk
Summary of Contents for Klever Desk
- Page 1 Klever Desk Flush Mount Handset (Upgrade) ™ Operating Instructions Designed in Europe, but built for corporate New Zealand workplaces, Klever Desk ™ hand control complements the function with its four-digit display, and space for up to two saved memory positions.
- Page 2 Initial Setup Procedure & Manual Reset Risk of minor or moderate injury through crushing. Collision Detection (ISP) is inactive during start-up and reset processes. This may lead to minor or moderate injury through crushing. Ensure that no persons or objects are in the table’s range of motion. NOTICE Operating the table system when it is not properly connected can damage the product.
- Page 3 Adjusting the Table Top Height Risk of minor or moderate injury through crushing Your fingers may be crushed when you attempt to change the height of the table. • Keep fingers away from moving parts • Ensure that no persons or objects are in the table’s range of motion INFO The Table Top will move up or down until the UP or DOWN Key is released, or if a predefined stopping point has been reached.
- Page 4 Adjusting the Table to a Memory Position Press and hold the required Memory Position Key (e.g. 2). > The Table Top will move until the saved Table Top height has been reached. If you release the Key before the Memory Position is reached, the table will stop. Release the Memory Position Key >...
- Page 5 Container and Shelf Stop Positions These features can limit the movement area of the Table Top (if e.g. a container is below the table or a shelf is above it). Container Stop Positions become the new lowest end position, Shelf Stop Positions the highest. INFO Container Stop Positions can only be saved in the lower half of the movement area, Shelf Stop Positions in the upper half.
- Page 6 Message Required Actions Internal Error Channel 1 Disconnect the Control Box from the Mains. Contact KLEVER for further information. Internal Error Channel 2 Disconnect the Control Box from the Mains. Contact KLEVER for further information. Disconnect the Control Box from the Mains. Fix the external short circuit. Ensure all Defect Channel 1 cables are connected correctly.
- Page 7 NOTICE Do not operate the table system if problems persist. Contact KLEVER for further information. NOTICE The Middle Switch is only fitted to certain versions of the SMARTneo-2G. Contact KLEVER if you are unsure which version you have. kleverdesk.co.nz...
Need help?
Do you have a question about the Desk and is the answer not in the manual?
Questions and answers