Care And Maintenance; Service Information; One-Year Limited Warranty; Troubleshooting - Stanley FATMAX PP1DCS Instruction Manual

circuit. The USB Power/Fault Indicators are divided into an upper set and a lower
set. The upper set detects fault conditions in the first two USB Ports; the lower set
monitors in the last two USB Ports. If a fault condition exists in either of the first
two USB Ports, the upper set of USB Power/Fault Indicators will flash blue. If a fault
condition exists in either of the bottom two USB Ports, the lower set of USB Power/
Fault Indicator will flash blue. In either case, the backlit LCD screen will continuously
display the following:
The Fault Icon will flash. The USB Ports will automatically shut down. Should this
occur, disconnect the USB-powered device and press the USB Power Button again
to turn off the USB Ports immediately. Make sure the unit does not need to be
recharged. Allow the unit to cool down for several minutes before attempting to
use the USB Ports again. If a fault occurs again, make sure that the total draw of
all USB devices plugged into the top two USB Ports does not exceed 3.1A and/or
the total draw of all USB devices plugged into the bottom two USB Ports does not
exceed 3.1A. If an individual USB device is within specifications and the fault occurs,
have the USB device checked for malfunction and do not continue to use it with
these USB Ports.
Using the USB Ports
1. Press the USB Power Button to turn on all four USB Ports. A beep will sound,
the USB Power/Fault Indicators around each of the four USB Ports will light
blue and the backlit LCD screen will continuously display the following:
The Battery Status Icon and Battery Voltage Indicator will light solid, as well as
the USB Icon, indicating the USB ports are ready to use.
2. Plug the USB-powered device into the USB power port(s) and operate normally.
3. Press the USB power button again to turn off the USB Ports.
Periodically check the unit's battery status on the backlit LCD screen. Four solid bars
in the battery icon indicates a full battery. When the battery level is nearly empty
with only one solid bar or completely empty with 4 empty bars, the unit must be
recharged at this time or the unit's built-in low voltage protection will activate. The
empty Battery Status Icon will flash for a short period of time before automatic
shut down.
IMPORTANT: Make sure the USB Ports are turned off when the unit is being
recharged or stored.
Notes:
This unit's USB Ports do not support data communication. They only provide power to external USB-
powered devices. The top two USB Ports provide a total of 3.1A (5V each). The bottom two USB Ports
provide a total of 3.1A (5V each).
Some household USB-powered electronics will not operate with this unit.
LED AREA LIGHT
The built-in 3-LED area light is controlled by the Area Light Power Button on the
control panel (refer to the "Features" section to locate). Press the Area Light Power
Button once to turn the light on. Press the Area Light Power Button again to turn
the area light off.
IMPORTANT: When the Area Light Power Button is pressed to turn it on, a beep
will sound. The backlit LCD screen will turn on for 10 seconds (only) and will then
continuously display the Battery Status Icon and the Battery Voltage Indicator.
Periodically check the unit's battery status on the backlit LCD screen. Four solid bars
in the battery icon indicates a full battery. When the battery level is nearly empty
with only one solid bar or completely empty with 4 empty bars, the unit must be
recharged at this time or the unit's built-in low voltage protection will activate. The
empty Battery Status Icon will flash for a short period of time before automatic
shut down.
IMPORTANT: Make sure the Area Light is turned off when the unit is being
recharged or stored.
PP1DCS_ManualENSP_040721.indd 10-11 PP1DCS_ManualENSP_040721.indd 10-11

CARE AND MAINTENANCE

All batteries lose energy from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, we recommend that the battery is
charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer
surfaces of the unit with a soft cloth.
There are no user-replaceable parts. Periodically inspect the condition of adapters,
connectors and wires. Contact manufacturer to replace any components that have
become worn or broken.
BATTERY
Please be advised that the battery is designed to last the service life of
the unit and is not replaceable, removable or serviceable. Service life is
dependent on a number of factors including but not limited to the number of
recharge cycles, and proper care and maintenance of the battery by the end user.
Contact manufacturer for any information you may need.
Safe Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid
battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.

TROUBLESHOOTING

Unit will not charge
• Make sure all of the unit's functions are turned off.
• Make sure a suitable gauge extension cord is properly connected to both the unit
and a functioning AC outlet.
Unit fails to jump-start
• Make sure unit's Jump Starter Power Switch is in the on position.
• Make sure a proper polarity cable connection has been established.
• Make sure the unit is not being operated in the Compressor mode.
• Check that the unit has a full charge. Recharge the unit if necessary.
Portable compressor will not inflate
• Make sure the Compressor Power Button has been pressed to turn the
compressor on.
• Make sure the unit is not being operated in the Jump Starter mode.
• Make sure the Sure Fit nozzle is securely screwed on to the valve stem when
®
attempting to inflate tires; or that the nozzle adapter is securely screwed into the
Sure Fit ® nozzle and is inserted properly into the item to be inflated on all other
inflatables.
• Check that the unit has a full charge. Recharge the unit if necessary.
USB power port will not power appliance
• Make sure the USB Power Button is in the on position.
• Make sure all the USB Power/Fault Indicators light solid blue. If a fault condition
exists in either of the first two USB Ports, the upper set of USB Power/Fault
Indicators will flash blue. If a fault condition exists in either of the bottom two
USB Ports, the lower set of USB Power/Fault Indicator will flash blue. Refer to the
Important Notes in the "USB Ports" section to remedy any faults.
• Make sure that the total draw of all USB devices plugged into the top two USB
Ports does not exceed 3.1A and/or the total draw of all USB devices plugged into
the bottom two USB Ports does not exceed 3.1A.
• Some USB-powered household electronics will not operate with this USB charging/
power port. Check the manual of the corresponding electronic device to confirm
that it can be used with this type of USB charging/power port.
• Check that the unit has a full charge. Recharge the unit if necessary.
LED area light does not come on
• Make sure the area light power button is in the on position
• Check that the unit has a full charge. Recharge the unit if necessary.
10
ACCESSORIES
Recommended accessories for use with your tool may be available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at 1-877-571-2391.
The use of any accessory not recommended for use with this appliance could
be hazardous.

SERVICE INFORMATION

Whether you need technical advice, repair, or genuine factory replacement parts,
contact the manufacturer at 1-877-571-2391.

ONE-YEAR LIMITED WARRANTY

The manufacturer warrants this product against defects in materials and
workmanship for a period of ONE (1) YEAR from the date of retail purchase by the
original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the
defective product can be replaced or repaired in the following ways: (1) Return the
product to the manufacturer for repair or replacement at manufacturer's option.
Proof of purchase may be required by manufacturer. (2) Return the product to the
retailer where product was purchased for an exchange (provided that the store is a
participating retailer). Returns to retailer should be made within the time period of
the retailer's return policy for exchanges only (usually 30 to 90 days after the sale).
Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during shipping;
alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you
may have other rights which vary from state to state or province to province. This
product is not intended for commercial use.
Be sure to register your product at https://www.baccusglobal.com/registration to
receive important product information, special promotions and offers, and more.

SPECIFICATIONS

Boost Ampere: 12V DC, 1200A peak battery, 500A instant
Battery type: Maintenance-free, sealed lead acid, 12VDC
AC input: 120V AC, 60Hz, 13W
Area light: 3 white LEDs
USB ports: 5V DC each, 6.2A total (3.1A total in
the top two USB Ports; 3.1A total in the
bottom two USB Ports)
Compressor maximum pressure: 120 PSI
Sure Fit ® is a registered trademark owned by Baccus Global, LLC.
STANLEY ® AND THE STANLEY ® LOGO ARE Imported by Baccus Global LLC,
REGISTERED TRADEMARKS OF STANLEY 621 NW 53rd St., Suite 450, Boca Raton, FL 33487
BLACK + DECKER INC. OR ONE OF ITS AFFILIATES, www.baccusglobal.com 1-877-571-2391
AND ARE USED UNDER LICENSE.
RD040721
11
4/7/2021 11:58:05 AM 4/7/2021 11:58:05 AM