Advertisement
NAME PARTS
1. Loop
2. Volume Up/Skip Forward
3. TWS Pairing Mode
4. Charging Port Cover
5. Play/Pause
6. Mode Switch
7. Volume Down/Skip Back
8. Power On/Off/LED
9. Built-in Mic
OPERATION
Charging up your Hydra Speaker
1. Locate the provided USB-A to Micro USB Cable.
2. Locate the Micro USB input (4) on the Hydra speaker.
3. Make sure that the Micro USB input (4) is clear of obstruction (dirt/dust etc).
4. Plug the USB-A end of the cable into your BYO wall or car charger making sure to lightly push it in (do
not push with excessive force).
5. Plug the Micro USB end into the Hydra Speaker's Micro USB input (4) and push home making sure it is
connected (do not push with excessive force).
6. Turn power on at the power source. A small LED will illuminate next to the Micro USB port indicating
that it is charging successfully. The small LED will extinguish when the Hydra speaker is fully charged
and is ready to be used.
7. To stop charging simply remove your charging cable from the Hydra speaker Micro USB port (4) or turn
off at the wall charger. Make sure to replace the charging port cover (4) to keep the unit sealed from
water ingress.
8. If the Hydra speaker sits idle charging and not playing music, it will automatically turn itself off to
conserve power after 10 minutes.
Powering On
1. Locate the Power On/Off button on the top of the Hydra speaker (8).
2. Press and hold the Power On/Off button (8) for 3 seconds to turn on.
3. The Hydra speaker will make an audible sound and immediately activate pairing mode. The LED
located on the power On/Off button (8) will flash on/off in second intervals.
Powering Off
1. Locate the Power On/Off button on the top of the Hydra speaker (8).
2. Press and hold the Power On/Off button (8) for 2 seconds to turn off.
3. The Hydra speaker will make an audible sound and shut down.
www.3sixtgear.com
or visit www.3sixtgear.com/support
2
Advertisement
