Sony E 3.5-5.6/PZ 16-50 OSS Service Manual page 16

Ver. 1.2 2013.04
4-3-2. E-Mount Lens Adjustment
NOTE: If the "PUSH ENTER" does not disappear even after pressing the ENTER key, press it again.
Do not touch the focus ring when performing operations on lens side, as the focus is on ∞ status during adjustment.
1. Method of Adjustment
1) Turn on the power of camera.
2) Start the E-Mount Lens Adjustment.
3) Click the button for corresponding adjustment item from Adjustment and Inspection.
4) Perform the adjustment according to the instruction on the adjustment screen.
NOTE: For the adjustment method of "Flange Back (S)" that require operations on lens side, see the following sections.
5) " FINISHIED" appears on the pop-up window when the adjustment is complete, then click the [OK] button.
* The adjustment result is displayed on the Message History window.
* Click the [Clear] button, the histories displayed on the Message History window will be deleted.
Fig.4-3-3
6) If all the adjustments for each required item are complete, click the [Iris Close] button.
7) Click the [ ] button on the upper right of the main window to finish E-Mount Lens Adjustment.
8) Turn off the power of camera.
SELP1650 (E 3.5-5.6/PZ 16-50 OSS) (E PZ 16-50mm F3.5-5.6 OSS)
2. Method for adjusting the "Flange Back (S)"
For item of the "Flange Back (S)", operation on lens side is required.
The method of adjustment is shown below.
1) The pop-up window shown in Fig. 4-3-4 appears, then press the ENTER key if the preparation for adjustment is complete.
NOTE: During adjustments, do not touch the focus ring.
Fig.4-3-4
2) An automatic zooming is begun, and then the screen shown in Fig.4-3-5 appears when the adjustment is complete.
Fig.4-3-5
3) Click the [ ] button on the upper right of the pop-up window.
* The "FINISHED" dialog box will appear when click the [ ] button.
4-4