tau TSG Installation Manual page 3

DIGITAL KEYBOARD TSG
Digital keyboard with remotely programmable codes (max. 50 codes) and mod. RXDC decoding receiver.
KEYBOARD INSTALLATION
●
Remove the screw cover (fi g. 2) with a screwdriver (fi g. 1);
●
after having removed the screws (fi g. 3), remove the keyboard front from the battery casing;
●
connect the battery to the keyboard front as shown in fi g. 4;
●
fi x the battery casing to the chosen support (use 5 mm Ø screw anchors if fi xing the keyboard to the wall
or 3.5 mm Ø self-drilling screws for metal or steel supports, or 3.5 mm Ø self tapping for wooden or similar
supports), making sure that the writing is at the top (fi g. 5) so that possible condensation can drain (1 fi g.
5);
●
Once the battery casing has been fi xed to the support, fi t the keyboard front with the battery connected and
fi x it with the 2 supplied screws (fi g. 6);
●
Finally simply push the screw cover into place (fi g. 7).
MODIFICATION OF THE MASTERCODE
The factory setting of the mastercode is: 1234.
To modify it, introduce the factory code following the sequence (1234), then
introduce the new code (4 numbers) and confi rm by repeating the new
sequence of numbers.
N.B. The new code is now memorised.
It is a good idea to note down the new Mastercode.
MEMORY RESET
The Mastercode is required in order to begin the memory reset and creation and
cancellation of a code.
The memory should ideally be reset before introducing your code. To do so,
perform the following procedure:
Mastercode
The operation is confi rmed with a single long beep.
CREATION OF A NEW CODE (E.G. 1111 – PERSONAL CODE)
The codes must have a minimum of 2 and a maximum of 4 digits.
After the memory has been reset, proceed with the creation of a new code:
Mastercode
(personal code)
The operation is confi rmed with a single long beep.
TRANSMISSION OF THE CODE TO THE RECEIVER
Before proceeding with the code transmission, make sure you are in the programming mode on the mod. RXDC
receiver (Press the PS1 button on the receiver – once to select channel 1 of the receiver, twice for channel 2,
three times for channel 3 and four times for channel 4 -, the red LED that corresponds to the selected channel
will light confi rming that the programming phase is active), then proceed as follows:
(personal code)
The red LED on the receiver switches off confi rming that the transmission has taken place.
CANCELLATION OF A CODE
Proceed as follows to cancel a code from the keyboard:
Mastercode
(personal code)
The operation is confi rmed with a single long beep.
Each time a code is cancelled from the keyboard it is also advisable to cancel it from the related channel on the
receiver so as to avoid a build-up of unused codes on the receiver (max. 64 codes per channel).
N.B. If the code is introduced incorrectly the keyboard emits a double beep error signal when the
button is pushed. Repeat the correct sequence of the set code.
TAU
Srl
Mastercode
.
.
.
Mastercode
.
(personal code)
(personal code)
TSG
English
3