Graco 4EVER 4-IN-1 CAR SEAT Instruction Manual page 102

Hide thumbs Also See for 4EVER 4-IN-1 CAR SEAT:

How to Lock Your Lap and Shoulder Vehicle Seat Belt

Note: With the vehicle seat belt in this locking mode, all the tension is

upwards in the shoulder belt. This may start to tilt your car seat sideways.

If this happens, use a locking clip instead of this switching the retractor.

See Sliding Latch Plate and ELR Retractor.

Sliding Latch Plate and Switchable

Retractor

A latchplate that slides freely on the belt

webbing and cannot, by itself, hold the belt

snug around a car seat.

When installing the car seat, route the vehicle

seat belt through the proper belt path and

buckle it in. Slowly pull the shoulder belt all

the way out to switch it to locking mode.

Then, as you pull the vehicle seat belt tight,

feed all the slack back into the retractor.

Grab the sides of the seat at the belt path and

slide the seat side-to-side and front-to-back. The

seat should not move more than 2.5 cm (1 in).

102