Final F100i User Manual page 16

Theoretically, the smoothest low-frequency response is obtained when the subwoofer is as close as
possible to the listener's ears. The received sound from the subwoofer is then dominated by the direct
radiation rather than by room resonances. Practically, the subwoofer should be placed on the base line
between the front panels. That's also advisable from a phase perspective and if the subwoofer outputs
frequencies higher than 100Hz. You cannot locate frequencies below 100Hertz. If the output is above
100Hz, it's easy to locate the sound coming from the subwoofer. Then, it's common wisdom to keep
the sub near the front panels and not along the wall or in the corner.
If you don't want to put the sub between the front panels and if the output is below 100Hz, the second
best location is nearby the corner of the room, consistent with the acoustic theory that all the room
modes will be excited evenly from this location. But, useful lessons learned from the real world tells us
that the best approach in coping with subwoofers is to use your ears and play around a little bit. For
bigger rooms it is preferable to use two subwoofers in each corner, near the front panels.
Can I mix and match the Final panels and subwoofers?
Our lines of loudspeakers and subwoofers are modular, scalable and customizable. Basically, we do
have a line for home theatres and a line for professionals and most discriminating audio consumers.
The home theatre packages will bring you five panels in one box and additional subwoofers and
optional floor stands. But, because we're modular and customisable, nothing stops you to design your
own home theatre configuration, using any combination of Final panels you like. Stereo-systems and
home theatres are also scalable. Depending on your room's sizes, you can build a system with small
panels, but also head towards a theatre consisting of large F600i electrostatics. It's all up to you and
your dealer might give you some good advice. The Final family of electrostatics is arguably the most
flexible offering in the world.
What are the key features of Final electrostatic loudspeakers?
The Inverter technology represents a major breakthrough in electrostatic loudspeaker design.
High resolution and detail: The diaphragm's combination of low mass together with instant acceleration
and deceleration, will bring a very natural and fast reproduction of the audio signal.
Huge stereo stage: The application of the patented inverter technology will bring a wide stereo stage,
without the 'hot spot' traditional electrostatic loudspeakers are known for.
Easy amplifier match: The inverter technology will raise the impedance to values comparable with most
dynamic loudspeakers in the market. You can drive any Final electrostatic loudspeaker with any good
amplifier, delivering 35-100 watt of power.
Sound: Final electrostatic loudspeakers do have a low distortion, good dynamic behaviour, neutrality,
speed, clarity and low-level resolution.
Design: Final electrostatic loudspeakers are basically elegant flat panels and they combine perfectly
with flat panel screens and televisions.
Any size: The Final family of electrostatic loudspeakers starts with small high definition panels for
smaller rooms and customers on a tight budget. The smaller models do have the same socic qualities
as the larger panels.
Modular and flexible: Although Final Sound can provide you with standard home theatre packages you
can basically build theatre and sound systems with any combination of panels. It can suit your tastes,
your room size and your budget.
Specially designed subwoofers: Most of our electrostatic loudspeaker panels need a subwoofer. Final
Sound offers a family of subwoofers, which are matched perfectly in terms of speed, articulation,
dynamic behaviour and power output.
Placement: depending on the panel's size and application, we deliver footplates, floor stands, set tops
and wall mounts.
100i
FINAL SOUND Loudspeaker Manual vs. 2.0 -US- c FS 2008 16
.