Disconnecting Lp Gas Tank - BRAND-MAN RUSTLER 4B GRAY Owner's Manual

USING, CONNECTING & DISCONNECTING LP GAS TANK
The installation must conform with local codes or, in the absence of local codes,
with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas
and Propane Installation Code CSA B149.1, or Propane Storage and Handling
Code, CSA B149.2, or the Standard for Recreational Vehicles, ANSI A119.2/NFPA
1192, and CSA 2240 RV Series, Recreational Vehicle Code as applicable.
Use standard flexible tube with length less than 1.5 m. the tube shall be
readily visible across its entire length for inspection after installation.
To operate, you will need on precision-filled standard barbecue grill LP gas tank
with external valve threads.
CAUTION: LP gas tank must be properly disconnected and removed
prior to moving this appliance
Connecting LP Gas Tank
1. Before connecting, be sure there is no debris caught in the head of the LP
gas tank, head of the regulator valve or in the head of the burner or burner
ports.
2. Connect regulator/hose assembly to tank by turning knob clockwise until it
stops. The cylinder supply system must be arranged for vapor withdrawal.

Disconnecting LP Gas Tank

1. Before disconnecting, make sure the LP gas tank valve is "CLOSED. "
2. Disconnect regulator/hose assembly from LP gas tank by turning knob
counterclockwise until it is loose.
CAUTION: LP gas tank must be properly disconnected and removed prior to
moving this appliance.
3. Place the protective cap cover on the LP tank and store the tank outdoors in
a well ventilated area out of direct sunlight.
OPERATING INSTRUCTIONS
Burner Connections
1. Make sure the regulator hose and valve connections are securely fastened
to the burner and the tank.
2. Visually check the connection between theburner/venturi tube and orifice.
3. Make sure the burner/venturi tube fits over theorifice.
WARNING: Failure to inspect this connection or follow these
instructions could cause a fire or an explosion which can cause death,
serious bodily injury or damage to property.
4. Please refer to diagram for proper installation (Figure 1).
5. If the burner/venturi tube does not rest flush to the orifice, as shown, please
contact Captivate Brands USA, Inc. for assistance.
Rustler 4B Gray
BMRUS4BGRAY
20 lb
9 kg
12.2 in. / 31cm
Figure 1
LP Gas
Valve with
Orifice
Burner/
LP Gas
Venturi Tube
Connection
26