Advertisement
OUT OF VEHICLE:
SURFACE CHARGE
IN VEHICLE? NO
B. The tester will resume testing after it detects that the surface charge is removed.
5.3.11.
Test the battery for a few seconds.
5.3.12.
Press the ◄ ► key to select battery fully charged or not if tester asks.
Press ENTER to confirm choice.
5.3.13.
When the test is completed, the display shows the actual volts and the actual CCA and internal resistance. (Press the ◄ ► key to
read: SOH (STATE OF HEALTH) and SOC (STATE OF CHARGE)).
5.3.14.
One of six test results will be displayed:
GOOD & PASS
* The battery is good and capable of holding a charge.
GOOD & RECHARGE
* The battery is good but needs to be recharged.
CAUTION
*The battery may be serviced but decrease the capability of starting the engine gradually.
The battery may fail under extreme climate conditions. There may be a poor connection between
the vehicle and the battery affect the charging function. Please pay attention to the battery for
replacement consideration and charging system checking.
RECHARGE & RETEST
* Battery is discharged, the battery condition cannot be determined until it is fully charged.
Recharge and retest the battery.
BAD & REPLACE
* The battery will not hold a charge. Replace immediately.
© Jack Sealey Limited
Original Language Version
TESTING
TESTING
IS BATTERY
CHARGED?
YES/NO
GOOD & PASS
VOL:
XX.XX V
CCA:
XXXX CCA /SAE
IR:
XX.XXMΩ
GOOD & RECHARGE
VOL:
XX.XX V
CCA:
XXXX CCA /SAE
IR:
XX.XXMΩ
CAUTION
VOL:
XX.XX V
CCA:
XXXX CCA /SAE
IR:
XX.XXMΩ
RECHARGE & RETEST
VOL:
XX.XX V
CCA:
XXXX CCA /SAE
IR:
XX.XXMΩ
BAD & REPLACE
VOL:
XX.XX V
CCA:
XXXX CCA /SAE
IR:
XX.XXMΩ
BT2011 | Issue:1 02/03/20
Advertisement
