Subscribe to Our Youtube Channel
Related Manuals for Labnet Accublock D1301
Summary of Contents for Labnet Accublock D1301
- Page 1 Labnet Accublock™ Digital Dry Bath Instruction Manual Catalog Numbers: D1301, D1301-230V D1302, D1302-230V D1304, D1304-230V This manual is available in additional languages at www.labnetlink.com.
-
Page 2: Table Of Contents
Table of Contents 1.0 Introduction ................. . .1 2.0 Safety Information . -
Page 3: Introduction
1.0 Introduction Labnet single, dual, and quad Accublock™ Digital Dry Bath Incubators provide comprehensive designs for a wide variety of life science research applications. Excellent temperature control figures can deliver accurate and reliable experimental results from one experiment to another. -
Page 4: Specifications
Allow sufficient room around the unit for access and cooling. Six inches minimum on all sides is suggested. Plug the unit into a properly grounded outlet. Using the lifter, insert the block(s) into the well. The unit is now ready for use. LABNET MICROTUBE SHAKING INCUBATOR... -
Page 5: Controls
6.0 Operation 1. Place Labnet Dry Bath Incubator on a sturdy and level surface in a safe, dry place, away from laboratory traffic. 2. Ensure that the AC power switch is OFF, then plug the three-pronged power cord into a grounded three-prong AC outlet of the appropriate voltage (115V or 220V as indicated on the rating sticker near the AC cord on the back of the unit). -
Page 6: Calibration
The Digital Dry Baths have a USB unidirectional data port. A software and cable are available which allow a user to use a desk top or lap top computer to record and/or print a record or the temperature profile produced by the dry bath. LABNET MICROTUBE SHAKING INCUBATOR... -
Page 7: Troubleshooting Guide And Service
5. Follow calibration procedure Should you have a question about the operation of the Labnet Digital Dry Bath or if service is required, contact Customer Service. Do not send in a unit for service without first calling to obtain a repair authorization number. -
Page 8: 11.0 Limited Warranty
Consequently, the buyer shall follow the instructions for reuse and recycling of waste electronic and electrical equipment (WEEE) provided with the products and available at www.corning.com/weee. LABNET MICROTUBE SHAKING INCUBATOR... - Page 9 To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use only. Not intended for use in diagnostic or therapeutic procedures. Corning Life Sciences makes no claims regarding the performance of these products for clinical or diagnostic applications. For additional product or technical information, visit www.corning.com/lifesciences or call 800.492.1110.
Need help?
Do you have a question about the Accublock D1301 and is the answer not in the manual?
Questions and answers