Advertisement
Freewheel
Outer side of top gear
adjustment
Guide
Pulley
Tension
SIS cable
Pulley
adjuster
High gear
adjustment
screw
Low gear
adjustment
screw
Barrel
adjuster
Cable
anchor bolt
screw
Chainguide clearance
of 1-3mm
Outer chainguide
Inner
chainguide
SERVICE & TECHNICAL SUPPORT
Monday - Friday 8:00 a.m. to 5:00 p.m. Pacific Time
FINAL CHECK
may blo
Tighten both front/rear wheel axle nuts or the quick release mechanism securely. Failure to do this may cause the
fron
•
are c
any necessary adjustments.
•
•
•
•
Correct maintenance of your bicycle will ensure many years of happy riding. Service your bicycle regularly by referring to the relevant
DERAILLEUR
Although the fron
need to inspect and readjust both before riding the bicycle.
Pulley
screw
Rear Derailleur
the smallest sprocket. Adjust the High limit screw so the guide pulley and the smallest
sprock
th
qu
Adjustment
ge
screws
will loosen the cable tension and move the chain away from the wheel, while turning
coun
Sh
Low limit scr
are aligned v
gear is achie
cable is adjusted properly.
Ensure all bolts ar
Do not ride a bicycle tha
adjustments may cause irreparable damage to the bicycle and/or bodily
injury
load, nor pedal backwar
the chain and cause serious damage to the bicycle and/or rider.
FRONT DERAILLEUR
Shift both shifters to the smallest number indicated and place the chain on the
corresponding cog and chainring. Disconnect the front derailleur cable from the cable
anchor bolt. Check the position of the front derailleur; it should be parallel with the outer
chainring and clear the largest chainring by 1-3mm whenfully engaged. With the chain on
the smallest chainring in front and the largest cog in back, adjust the Low limit screw so
the chain is centered in teh front derailleur cage. Reconnect the cable, pull any slack out,
and tighten the anchor bolt securely. Shift the font shifter to the largest chainring. If the
chain does not go onto the largest chainring, turn the high limit screw in 1/4 turn
increments counter-clockwise until the chain engages the largest chainring. If the chain
falls off the largest chainring, and into the pedals, adjust the HIGH limit screw in 1/4 turn
increments clockwise until the chain no longer falls off. Shift through every gear, using the
barrel adjusters to fine tune each transition. The barrel adjuster for the front derailleur is
located on the front shifter where the cable comes out of the shifter. Clockwise loosens
the cable tension and directs the chain closer to the frame, while counter-clockwise
tightens the cable tension and directs the chain away from the frame.
TOLL FREE 1.855.521.1127
www.infinitycycleworks.com
copyright 2018 - Infinity Cycle Works Ltd.
Advertisement
