Safety Instructions And Handling - Spanset Magnum-X Operation Manual

are made of reinforced synthetic fibres (e.g. polyester or polyamide). Their
production is DIN EN ISO 9001 certified.
$

2 Safety instructions and handling

Avoid folding the sling at the anchor point (e.g. crane hook or fit-
ting) as this may lead to loss of strength and premature wear
$
After each lifting operation, the round sling must be repositioned in
both the anchor point and crane hook. Changing contact point increa-
ses service life and safety because tension is applied to the sling evenly.
#
Only trained (authorized) persons may fasten loads.
#
When choosing and using slings, the weight and fastening
method
geometry, surface condition and design features of the load are crucial
criteria for choosing the sling.
#
A sling's nominal load capacity can change depending on the
fastening method. The change in load capacity is shown by the
load fastening factor (M). A sling's nominal load capacity is indicated in
the "simple direct" fastening method. The load fastening factor (M) for
the rest of the fastening methods
operating manual.
#
Using Magnum-X round slings hangers with chemicals is permit-
ted only with manufacturer approval. The necessary data include:
chemical, concentration, temperature and retention time.
#
If contact with chemicals cannot be avoided when using Magnum-
X round slings, SpanSet offers a residual strength test for an extra
fee for the operator's hazard analysis. Here, the chemical, dwell time,
temperature and concentration, among other things are to be specified.
SpanSet reserves the right to refuse the residual strength test if exami-
ners are endangered or testing machines are contaminated.
b
14 15 16 17 18 19
must be considered . The weight,
14 15 16 17 19
14
can be found in this
22
.