Table of Contents
Advertisement
5.2.2 Installation Procedure for
Pre-filter & Bag Filter
The pre-filter and primary bag filter must be slid into and out of their
respective tracks in a delicate and uniform fashion to avoid damage
to the filter or jamming inside the tracks.
Be sure the bag filter is slid into place prior to hanging the individual
bags/loops.
For units that are two filters deep, be sure to push the first filter all
way toward the back of the primary filter cabinet until it contacts the
stop. Reference balloon #1 in Figure 5A.
The hanging rod is to be inserted through each filter loop and hung
from a bracket on each side of the primary filter cabinet. Work from
the back of the cabinet toward the front.
Center the filter on each rod, and each rod on its respective bracket.
Verify all bags are hung and supported properly before securely clos-
ing and locking each door/latch. Reference balloon #2 in Figure 5A.
Filter Type
Aluminum Mesh Pre-filter
Coalescing Primary Filter
Fiberglass Bag Primary Filter
95% O/M A er-filter
95% O/M for Enclosed Cabinet
HEPA A er-filter
HEPA for Enclosed Cabinet
Replacement Filter Quan
Part #
SHM-11
33-10117
1
33-10128
4
33-0221
1
33-10129
1
33-10131
1
33-10082-0002
1
33-10132
1
16
5.3 Contaminant Removal
Drain the sump regularly. The required frequency of this action will be
dictated by the load rate and operation.
Be sure oil is not accumulating in any location that could cause
malfunction or a safety concern including, but not limited to, the
motor cabinet, filter header plate, and tube sheet panel.
Be sure to dispose of, or recycle, any waste oil properly.
Dispose of waste in accordance with applicable local, state, and
federal regulations.
es
SHM-12
SHM-21
SHM-31
2
2
3
8
8
12
2
2
3
2
2
2
2
2
2
2
2
2
2
2
2
SHM-22
SHM-32
4
6
16
24
4
6
4
6
4
6
4
6
4
6
Advertisement
Table of Contents
