Table of Contents
Advertisement
Information Screen:
Figure 9
The information screen will provide a phone number for customer
service. There is also a web address for our website that can be
used to locate your nearest representative.
4.3.4 Auto-Flow Screen
Figure 10
When Auto-Flow is installed and activated the blower screen will
look like Figure 10. Refer to section 4.3.6 to activate the Auto-
Flow option and to make adjustments to your flow target. The
Auto-Flow blower screen will show the target flow, the actual
flow, the blower speed, and the % of total speed available. The
screen will also show blower status. If there is a warning or fault,
refer to the troubleshooting section for guidance.
4.3.5 After-Filter
Figure 11
When the screen is active you will see the differential pressure
across the filter. The system will monitor this pressure and give
warnings and faults as the differential pressure changes. The
after-filter does not get cleaned by the system and has a finite life
based on the pressure drop across the filter. When the pressure
drop increases to a point that the filter can no longer provide
proper airflow, the fault symbol will appear. You will need to
replace the filter at that time.
4.3.6 Customer Settings
The standard customer settings screen shown in Figure 12 will allow
the operator to make General Settings changes without a password.
The Locked Settings will require a password to be entered. The
default password is 4440.
The General Settings selection will allow the operator to change
the units and check service of the major components like the
blower. These settings are not password protected. To select one
of the items just touch the box with the item you want to make
a change too.
The Locked Settings selection will allow the operator to select
options of the system. One option is Machine Interlock. With
Machine Interlock the operator can allow another device (CNC
machine center, plasma table, or weld machine) to turn the SHM
on when the primary device is in operation. When this option is
selected (see Figure 20) the Blower Power button in Figure 6 will
put the unit in standby when touched by the operator. When this
setting is selected the indicator to the right side will change from
OFF to ON and turn green.
When After-Filter and/or Auto-Flow options are ordered, they will
appear on the Customer Settings screen as shown on Figure 13.
When the units selection is made on the Customer Settings
screen, you will see the screen as shown on Figure 14.
13
Figure 12
Figure 13
Figure 14
Advertisement
Table of Contents
