Table of Contents
Advertisement
Quick Links
#892
AIR SCRUBBER
120V
INFORMATION
&
OPERATING
INSTRUCTIONS
CAUTION: DO NOT OPERATE MACHINE UNTIL YOU HAVE READ
ALL SECTIONS OF THIS INSTRUCTION MANUAL
IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY
1. NEVER use the Air Scrubber without both the HEPA and the primary filter installed.
2. Use the Air Scrubber indoors only, and only for its designed purpose.
3. Always follow EPA approved guildelines for site preparation and contaminant disposal.
4. NEVER clean or re-use a HEPA filter. Handle and dispose of the HEPA filter as you would
other hazardous waste.
5. Keep the air inlet and outlet at least one foot from walls or other obstructions.
6. Plug the machine into a grounded 15 amp or greater outlet.
2-8-2010
1
Advertisement
Table of Contents
Related Manuals for Servpro AIR SCRUBBER 892
Summary of Contents for Servpro AIR SCRUBBER 892
- Page 1 #892 AIR SCRUBBER 120V INFORMATION & OPERATING INSTRUCTIONS CAUTION: DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THIS INSTRUCTION MANUAL IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY 1. NEVER use the Air Scrubber without both the HEPA and the primary filter installed. 2.
- Page 2 IMPORTANT SAFETY INSTRUCTIONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the following: NOTE: Read all instructions before using this machine.
- Page 3 INSPECTION: Carefully unpack and inspect the Air Scrubber for shipping damage. Each unit is tested and inspected before shipment. Any damage incurred during shipping is the responsibility of the carrier, whom you should notify immediately. FILTERS: The Air Filter must be used with the HEPA air filter and the Primary Filter. The HEPA Filter has an efficiency rating of 99.97% in the removal of particles as small as 0.3 microns.
- Page 4 HIGH CHECK CHECK FILTER LIGHT (1): This light will come on when the filters are loaded and need to be replaced. Always check the light with the switch on the HIGH setting. Turn the machine off to change filters. HIGH / LOW SWITCH (2): This is the main power switch; it has three positons: HIGH / OFF / LOW.
- Page 5 SET-UP: The Air Scrubber can be operated while sitting flat on the floor (#1) or in an upright position (#2), as shown below. Place the machine as shown in Figure 1 for large, open areas, or locations near the same height as the machine. Use the upright position for areas that are high above the location of the machine, such as ceiling ductwork or attic areas.
- Page 7 #892 AIR SCRUBBER 120V PART LIST ITEM QTY PART No. DESCRIPTION ITEM QTY PART No. DESCRIPTION ASFH-2 Filter Housing, green 29A 1 002050 Gasket, 1/4” X 92” 1014A Extrusion 2050B Gasket, 3/8” X 44” 1017 Guard, wire form, 18” Part of Fan Housing Bolt, 1/4-20 # 3/4”...
- Page 8 #892 AIR SCRUBBER 120V SPECIFICATIONS: Hepa Filter: DOP Certified 99.97 Two speed 1400/2200 CFM Blower: 1-3/4 hp, 14 amp peak Blower Motor: 130 lbs. Weight: 51L x 15-1/4W x 19-1/2H inches Dimensions: 1 year limited - parts Warranty: Lifetime Warranty on Body: 8 Inch transport wheel w/dolly design Transport: NOTES:...
Need help?
Do you have a question about the AIR SCRUBBER 892 and is the answer not in the manual?
Questions and answers