hole of 12mm diameter for the PDM Kit.
- If you needed to use your own threaded bolt make sure you use M10 metric thread.
- The cable organizer clip will help to tidy your wiring.
- Never use the Power Sting other than with the original m!ka Bushing. Table clamps
are not suitable to hold an MMS arm. Use a gripper to fix the Power Sting.
- When installing the m!ka Ceiling Mount it is your obligation to verify that your ceiling
and your fasteners are suitable to hold the load.
- When installing the m!ka Wall Mount it is your obligation to verify that your wall and
your fasteners are suitable to hold the load.
- Make sure you have checked the max. payload of your m!ka Monitor Arm. The infor-
mation is printed on the product label on the rearside of the QuickFix.
- See Page 21 for how to secure a minimum headroom under your monitor.
- In order to prevent unintended changes to the MMS height position simply remove
the thumbscrews by pulling them out. Before you remove the screws make sure they
are all properly tightend.
- The MMS QuickFix adapter is suitable to be used with VESA 75 and VESA 100 fixtures.
Page 13
Page 14
Page 15
Page 16
Page 17
Page 18
37