Network Connection - Datavideo PTC-280 Instruction Manual

6.

Network Connection

The Ethernet port on the back panel of your PTC-280 allows you to connect to
camera from the PC/Laptop with Static or dynamic IP addresses. To access and
modify these network settings, you will need to login to the camera's web
interface.
If this is your first time using the device, please note that the camera's default
IP address is 192.168.100.88.
Set up direct connection between the camera and your PC/laptop as depicted
in the diagram below; remember to manually assign an IP address of
192.168.100.X to your PC/laptop.
Ethernet Cable
192.168.100.88 192.168.100.x
On your PC/laptop, open a web browser and in the address bar, enter the
camera's default IP address, 192.168.100.88 then press the ENTER key which
should take you to login page of the web interface.
40