Configure groups ......................15 Configure floor push button as call push button ............. 15 Programming with Service Device TCSK-01 ..............15 General information on the conduit in TCS audio systems ......... 16 Principle loop resistance ..................... 17 Measure loop resistance ..................... 17 Cleaning ..........................
ZIT3030-0010. 3-wire technique necessary! The indoor station ISW3330 must not be used in call systems according to DIN VDE 0834 and EN50134. According to DIN 77800, a separate safeguard for emergency calls has to be installed.
07/2015 Max. number ISW3330 (only 3-wire operation possible) When using the power max. number supply and control unit of ISW3330 NBV3210, 3 strands VBVS05 (PSG02), 1 strand AS front-door station VS power supply and control unit IS indoor station Note: The max. number of AS which can be connected is limited and is descriped in their respective product infor-...
* The central can use the control function 8 resp. the floor call to allow the listen-in into rooms again. TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129...
Function description To listen-in into rooms It must be guaranteed that there is no way to listen-in into the room, in which the ISW3330 is installed, without the permission from the resident via keystroke at the call button. Lis- ten-in into the room is only possible, if the resident has called the central (by pressing the...
TIPP: Avoid tearing of the straps: To fix the cover at the straps, do not use counter-head screws without flat washers! TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129...
The upper cover can be removed at the un- derside (1). Lift the upper cover off the two upper adjust- ment increments (2). TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk...
Train radio sensors Training radio sensors can be implemented currently only with the configuration software configo™ (as of version 1.7.x). TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk...
Connect further wires with auxiliar terminals! Use only connection lines with identical diameter in one terminal contact. Wiring example floor push button floor push button TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk...
The optical and acoustic error indication is deactivated ex works. It can be activated for service purposes with the configuration software configo™ (see also Information, page 18). TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129...
This setting influences only the sensitivity of the microphone when listen-in into rooms. Note: During hands-free talking, the microphone sensitivity does not change. TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk...
07/2015 General information on the conduit in TCS audio systems The conduit is determined by structural conditions and is limited only by its length. Observe when selecting the cable length: the loop resistance must not exceed 8 Ω (table).
Remove stronger stains with a standard plastic cleaner. Conformity The declarations of conformity are available under www.tcsag.de, downloads, trade information. TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk...
10 pieces cover panels white 120 x 250 x 2 mm 0022930 radio receiver board 0022931 radio sensor,wristband 0022932 radio sensor, necklace TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk...
Page 19
This internal call from the central triggers a call at the indoor station ISW3330. A ring tone sounds, the lighting bar is lighting up green. If the resident is able to accept the call (by pressing the call button at the indoor station or the radio sensor), a manually con- trolled duplex communication is established.