How To Install - Panasonic FV-SCGPW1 Operating And Installation Instructions

How to Install

■ Before installation
Be sure to confirm that the following attachments are enclosed in the packing box.
If anything is missing, contact our After-Sales Center or your dealer.
Ventilator remote controller ----- 1 set
Signal cord ----------------------- 10 m
Screw (M4) ----------------------- 2 pcs
■ How to install
1. Embed and fix a switch box in the wall.
※Use a switch box of the right size for the
product. Refer to the external
dimensions of the product in page 4.
(Recommended size: 100 x 100 mm or
86 x 86 mm)
3. Plug the signal cord into the connector on
the rear cover. (Connect the other side of
the signal cord to the relevant ventilator.)
Rear cover
Signal cord
Connector
5. Reconnect the internal cord to the
front cover.
Front cover
Internal cord
Notice
Do not apply excessive force to the front cover.
•
Install the product at a height of 1 to 1.5 m from the floor.
•
Install the product vertically to the wall.
•
Leave a minimum clearance of 20 cm around the product.
•
Do not install the product where exposed to direct sunlight, heat or wind from an air conditioner.
•
Do not install the product near windows or doors.
•
Install the product in the same room as where the relevant ventilator is installed.
•
Do not put obstacles around the product.
•
Install the product at least 1 m away from TV, radio or PC.
•
Rubber packing --------------------------2 pcs
Operating and Installation Instructions -----1 set
2. Insert a flathead screwdriver into the groove at the
Switch box
(Not supplied)
Flathead
screwdriver
※Be careful not to damage the product.
※Do not apply tension to the internal cord.
4. Fix the rear cover to the switch box with screws.
※Cover the installation holes not used for
Switch box
6. Attach the front cover to the rear cover.
Rear cover
※Prevent the internal cord from being bitten by the
※Attach the front cover firmly.
underside of the product to remove the rear cover,
and unplug the internal cord. (Unplug the connector
on the front cover side.)
Groove
※Do not unplug this cord.
(Use supplied or commercially-available screws
suitable for the switch box.)
Rear cover
Screws
(supplied or
commercially-
available)
Rubber packing
installation with rubber packing.
Front cover
covers.
(A click will sound when installed correctly.)
Rear cover
Front cover
Internal cord
Switch box
Rear cover
English
3