Operation Of Remote Controller - Boss Audio Systems 758DBI User Manual

Operation of Remote Controller

1. POWER Use to turn receiver on/off
2.In BT mode, when receive a call, the LCD will
show the receive phone number, press this
button to accept the call.
3. In BT mode, when receive a call, the LCD will
show the receive phone number, press this
button to reject the call.
Please note (in BT connect mode):
When your phone is connect to the head unit, the
LCD will show BT-READY.
When dialling a call in connection status, the LCD
will show CALL OUT.
4.EQ(Preset Equalizer Curves)
Press repeatedly to cycle through these modes:
FLAT, CLASSIC, ROCK, POP, USER SET.
5.MUTE
Press this button to silence the audio. Press again to restore the previous
audio volume level.
6.PTY/LOC
In Radio mode, press this button to select PTY mode:
While selecting PTY TYPE, its selection is implemented by preset buttons as
described in preset key. (press one of the 6 preset buttons briefly and
repeatedly to select the PTY TYPE in the preset button) When POP M or
NEWS is on, the previous PTY program and PTY word is displayed on LCD.
If there are no keys entered for 2 seconds, previously selected PTY is searched.
During 1 loop, if desired PTY is not found, NO PTY is flashed, then return to
previous normal radio and PTY word disappear.
Press and hold this button to select Local/DX mode:
In some areas, reception of an AM station may be weak. Changing the reception
mode to LOC by pressing this button allows the receiver to skip the weaker
signals. Press again to return to DISTANT mode.
7.RDM/AF
In Radio mode, press this button to activated as AF mode on or off.
When AF switching mode is selected, the radio checks the signal strength of AF
all the time. The interval of checking time of each AFs depends on the signal
strength of current station, from a few minute for strong station to a few seconds
for weak station.
Every time that new AF is stronger than current station, it switches over to that
frequency for very short time, and NEW FREQUENCY is displayed for 1-2
second.
PDF created with FinePrint pdfFactory trial version
1
4 5
11
10
9
3
Page 8
http://www.pdffactory.com
iPod Playback Controls
Before removing the iPod from the dock, be sure to pause playback OR use
the MODE switch to change to another mode.
1 2 3
6
RPT
RDM
1 2 3
7
MODE
ENTER
6
4 5
8
-10 +10
12
2
To play tracks from a iPod, first be sure you have the proper dock adaptor
inserted in the docking drawer . Then insert the iPod. The display will show
" RMT ",
iPod indicating that the iPod unit has been recognized. Press
PLAY/PAUSE to begin playback.
'
Most of the iPod s
758DBI.
However, you can always control the
more convenient for you.
Please note that the
iPod units.
If it is not, you can still use the AUX input to connect the headphone output to
the 758DBI , but you will not be able to control the iPod playback this way.
IPod not recognized? Is iPod Enabled in the System Setting?
An iPod in the dock will only be recognized if the iPod function is enabled
in the System Settings. If the 758DBI does not recognize that an iPod is
present, check the System Settings to make sure that the iPod function
is enabled.
1.PLAY/PAUSE
Please to begin playback. To pause, press again. Press again to resume
playback.
2.RPT (Repeat Play Mode)
Press this button to repeat the playback of the current track.
TA
AF
5 4
menu functions can be displayed and controlled by the
iPod playback from the iPod itself if that is
758DBI is compatible with almost all of the available
Page 5
AUX IN