Advertisement
NOTE:
Damage resulting from chemical imbalance is not
covered by the warranty. Pool chemicals are potentially toxic and
should be handled with care. There are serious health risks from
chemical vapors and the incorrect labeling and storage of
chemical containers. Please consult your local pool supply
retailer for more information about chemical maintenance. Pay
close attention to the chemical manufacturer's instructions. Pool
damage resulting from misuse of chemicals and
mismanagement of pool water is not covered by the warranty.
IMPORTANT:
discolor the printing and all points of the pool material. It can also
damage the structure of the pool liner.
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase
of chemicals and pH kits. One of the most important factors to
increase the life of the liner is to keep continuously clean and
healthy water. Please strictly follow the instructions from
professional technicians for the water treatment through the
use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet
before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean
cloth.
7. Please be careful in case of rain water, kindly check that the
water level is not higher than the expected. If so, YOU HAVE
TO DISCHARGE THE EXCESS WATER.
8. If it rains, check that the water level is not higher than the
specified level. If water exceeds the specified levels, drain the
pool to the specified level.
Proper maintenance can maximize the life of
your pool.
During the season of use of the swimming pool, the filtration
system must be necessarily put into service every day, enough
time to assure at least a complete renewal of the volume of
water.
NOTE:
The pump is used to circulate the water and to
filter small particles. In order to keep your pool water clean and
hygienic, you must also add chemicals.
Repair
In the event of a leak, patch your pool using the underwater
adhesive repair patch provided. You can find the instructions in
FAQs on the support section of our website,www.bestwaycorp.com.
Over usage of chemicals can
For support please visit us at:
bestwaycorp.com/support
OLD EAST MAIN CO.
Tel: 86 513 8730 9333
Bestway (Nantong) Recreation Corp.
No.8 West Huimin Road, Rugao Economic
Development Zone, Rugao, Jiangsu, 226503, China
Dismantling
1. Unscrew the drain valve cap counter-clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the
hose in the area where you are going to drain your pool.
(Check local regulations for drainage by-laws).
3. Screw the control ring of the hose adaptor clockwise onto the
drain valve. The drain valve will be open and water will start
to drain automatically. Open the drain valve to the maximum
position.
4. Deflate the top ring by squeezing the air valve.
5. When the top ring is fully deflated, press the top ring down,
and tilt it to drain the pool easily. Completely drain the water
in the pool.
6. When draining is finished, unscrew the control ring to close
the valve.
7. Disconnect the hose.
8. Screw the cap back onto the drain valve.
9. Air dry pool.
Storage
1. Please remove all the accessories and spare parts of the pool
and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to
prevent pool from sticking together, fold pool carefully. If pool
is not completely dry, mold may result and will damage the
pool liner.
3. Store liner and accessories in a dry place with a moderate
temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be
stored as per above instructions also.
5. Improper draining of the pool might cause serious personal
injury and/or damage to personal property.
6. We strongly recommend the pool is disassembled during the off
season (winter months). Store in a dry location out of children's
reach.
NOTE:
If your purchased pool set do not have any
circulation system, you can purchase separately. But please
make sure the equipment can turn over total volume of pool
water no less than once every 12 hr. You can check the water
capacity on packaging to select suitable circulation system.
Pump provided for the circulation of water shall be tested by a
Nationally Recognized Testing Laboratory and certified to
conform to UL1081.
Also make sure the selected suction outlet sold with the pump
should be tested by a Nationally Recognized Testing Laboratory
and certified to conform to ASME/ANSI A112.19.8 or its
successor standard ANSI/APSP-16, in order to prevent suction
entrapment.
21
8
303021246635
Advertisement
