You Will Need The Following; Connecting The Ssd To A Desktop Computer - Verbatim Vi560 Manual

• Do not alter, modify, or disassemble the device.

You Will Need the Following

1. Verbatim Vi560 SATA III M.2 2280 SSD
2. Host laptop or desktop computer*
3. SATA III Cable (only needed if cloning existing SATA Hard Disk Drive (HDD) or SSD
device)*
4. A non-magnetic tip screwdriver suitable for opening the case, cover, and/or access
panel(s) of your desktop computer or laptop*
5. A non-magnetic tip screwdriver suitable for fastening the M.2 SSD device to the
motherboard*
6. A suitable screw to fasten the Vi560 SSD to your motherboard (typically included with
your motherboard)*
*Not included

Connecting the SSD to a Desktop Computer

1. Power off your desktop computer.
2. Unplug the power cable from the desktop computer.
3. Press the power button and hold it for a few seconds to discharge any remaining
electricity.
4. Locate the cover and/or access panel(s) for installing a SATA III M.2 SSD using your
computer's user manual.
5. Open the computer's cover or case and any associated access panel(s) to gain
access to the motherboard.
6. Decide whether you are replacing your existing SATA HDD or SSD OR if you are
installing your new SSD alongside an existing SATA HDD or SSD. Note: many
motherboards have at least (1) SATA III 2.5" ports and at least (1) SATA III M.2
available. Consult your motherboard documentation to con rm your options.
a. If you are replacing your existing HDD or SSD with a cloned drive or as a clean
installation:
i. Consult your motherboard documentation to locate the existing SATA III 2.5"
or M.2 port.
2